Insignia NS-MWF-2 Quick Setup Manual

Congratulations on your purchase of one of the highest
performing water filters on the market today. Insignia filters use
a high-grade coconut carbon that has 50% more micro-pores
than standard carbon. They also use fewer high-compression
binders, giving you the best water filtration possible.
Package contents
• Refrigerator filter(s) (1 or 2 pack)
• Quick Setup Guide
General installation guidelines
1 YOU MUST SOAK your new filter in water for 15 minutes prior to
installing it in your refrigerator. This is needed to remove air from
the carbon block.
2 It is normal for black carbon fines (particles) to appear on the outside
of your filter. This happens when the filter is jarred in shipping, it is
safe, simply wipe it off.
3 Connections on our filters are larger in size to prevent leakage. This
might require more hand leverage to install.
Installation:
*PUSH AND TURN HARD
To remove turn counter-clockwise
To install turn clockwise
Do not remove the O-ring
Filter receivers are designed to be flexible.
Don't worry, they won't break!
Before using your new product, please read these instructions to prevent any damage.
Refrigerator Filter | NS-MWF-2/NS-LT600B-2/NS-DA2920/NS-DA2920-2/NS-DA2903/NS-DA2903-2
4 After installing, run about two to three gallons of water through your
refrigerator's water dispenser to remove air and loose carbon pieces. The
water may be cloudy and sputter until the air is removed.
5 We apply a safe, NSF approved, food grade silicone lubricant to our filter
connectors (jelly like substance).
NS-DA2903 or NS-DA2903-2 (Samsung)
1 Remove the old filter by rotating it a quarter turn
counterclockwise, then pull it straight down.
The water automatically turns off.
2 Align the top of your new filter with the receiver,
then push it up until it stops.
3 Rotate the filter a quarter turn clockwise to
secure the filter.
NS-MWF-2 (GE, Hotpoint, Amana, and Kenmore)
1 Remove the old filter by rotating it a half turn
counterclockwise, then pull it straight down. The
water automatically turns off.
2 If you have a Kenmore refrigerator, check if there
is a plastic or metal cap that covers the top of the
old filter. If there is, pull off the cap and attach it to
your new filter. If there is not, continue to step 3.
3 Align the top of your new filter with the receiver,
then push it up until it stops.
4 Rotate the filter a half turn clockwise to secure
the filter, then twist a little more to prevent leaks.
Quick Setup Guide
NS-LT600B-2 (LG and Kenmore)
1 Remove the old filter by rotating a half turn
counterclockwise, then pull it out. The water
automatically turns off.
2 If you have a Kenmore refrigerator, check if there is
a plastic or metal cap that covers the top of the old
filter. If there is, pull off the cap and attach it to
your new filter. If there is not, continue to step 3.
3 Align the top of your new filter with the receiver,
then push it in until it stops.
4 Rotate the filter a half turn clockwise to secure the
filter, then twist a little more to prevent leaks.
NS-DA2920 or NS-DA2920-2 (Samsung)
1 Remove the old filter by rotating it a 1/4 turn
counterclockwise, then pull it out.
2 Align the top of your new filter with the receiver,
then push it up until it stops.
3 Rotate the filter a 1/4 turn clockwise to secure the
filter.
Before using your filter
If your refrigerator has a change filter indicator, reset it. See "Resetting your
filter indicator" for instructions.