Insignia NS-HAF-CIN-1 Quick Setup Manual

Congratulations on your purchase of one of the highest performing
water filters on the market today. Insignia filters use a high-grade
coconut carbon that has 50% more micro-pores than standard carbon.
They also use fewer high-compression binders, giving you the best
water filtration possible.
PACKAGE CONTENTS
• Refrigerator filter(s) (1 or 2 pack)
• Quick Setup Guide
GENERAL INSTALLATION GUIDELINES
• It is normal for black carbon fines (particles) to appear on the outside
of your filter. This happens when the filter is jarred in shipping. It is
safe, simply wipe it off.
• The filter connectors are larger to prevent leaks. You might have to
twist the filter hard to make sure the connection is secure.
Before using your new product, please read these instructions to prevent any damage.
Quick Setup Guide |
*Actual product may
vary slightly from
what is pictured
NS-HAF-CIN-1/NS-HAF-CIN-2/NS-HAF-CIN-2-C
INSTALLING THE WATER FILTER
Carefully remove the plastic cap from the new filter before installation
1 YOU MUST SOAK your new filter in water for 15 minutes prior to
installing it in your refrigerator to remove air from the carbon block.
2 Twist the old filter a quarter-turn counter-clockwise.
3 Pull the filter straight out and discard.
4 Push the new filter into the refrigerator until it stops.
5 Twist the filter a quarter-turn clockwise.
6 Please make sure the indicator arrows on the new filter are lined up with
the indicator arrow on the refrigerator after installation.
7 Run about two to three gallons of water through your refrigerator's water
dispenser to remove air and loose carbon pieces. The water may be
cloudy and sputter until the air is removed.
8 Reset your "change filter" indicator (if your refrigerator has one). See
below.
RESETTING YOUR CHANGE FILTER INDICATOR
Note: These are the most common filter reset instructions. If the instructions don't
work for your refrigerator brand, see the documentation that came with your
refrigerator.
REFRIGERATOR BRAND INSTRUCTIONS
Samsung Press and hold the ICE TYPE and CHILD LOCK
buttons for three seconds. The water filter
indicator should turn green.
Note: Only hold these buttons for three seconds. Holding
these buttons for five seconds cancels the reset. If you
cancel the reset, repeat the procedure.
Refrigerator Filter