Insignia NS-MWF-1 Quick Setup Manual

QUICK SETUP GUIDE
Refrigerator Filter
NS-MWF-1
PACKAGE CONTENTS
• Refrigerator filter(s) (1 pack)
• Quick Setup Guide
Before using your new product, please read these instructions to prevent any damage.
GENERAL INSTALLATION GUIDELINES
• It is normal for black carbon fines (particles) to appear on the outside of
your filter. This happens when the filter is jarred in shipping. It is safe,
simply wipe it off.
• The filter connectors are larger to prevent leaks. You might have to
twist the filter hard to make sure the connection is secure.
INSTALLING THE WATER FILTER
1 YOU MUST SOAK your new filter in water for 15 minutes prior to
installing it in your refrigerator to remove air from the carbon block.
2 Twist the old filter a quarter-turn counter-clockwise.
3 Pull the filter straight down and discard.
4 Push the new filter up into the refrigerator until it stops.
5 Twist the filter a quarter-turn clockwise.
6 Run about two to three gallons of water through your refrigerator's water
dispenser to remove air and loose carbon pieces. The water may be
cloudy and sputter until the air is removed.
7 Reset your "change filter" indicator (if your refrigerator has one). See
below.
RESETTING YOUR CHANGE FILTER INDICATOR
Note: These are the most common filter reset instructions. If the instructions don't
work for your refrigerator brand, see the documentation that came with your
refrigerator.
REFRIGERATOR BRAND INSTRUCTIONS
GE or Hotpoint Press and hold the reset water filter button on the
dispenser for three seconds.
Kenmore The water filter reset for Kenmore refrigerators
varies by model. See the documentation that
came with your refrigerator.