Playing A Disc - LENCO DVP-1023 CR Manual

Playing a Disc

Preparation for Playback
1.Make sure the Player has the power either from the battery
pack or the AC adaptor.
2.Load a disc, following these steps:
Open the top cover.
Press the OPEN button to open the disc cover.
Place a disc into the tray with the label side facing up.
Close the disc cover.
3.Slide POWER to ON to turn on the power.
Play
Press (on the remote control) or
play.
Resume
There are two ways to resume your playback when interrupted.
Method 1: for short time interruption
1.Press STOP ( ), the Player remembers where you stopped.
2.To resume, press PLAY, the Player will play from where you
stopped.
Method 2: for longer time interruption
1.Press OPEN to open the disc compartment door
2.You can turn off the power, and even remove the disc from the
desk, when you turn on the power and replace the disc, the
Player will play from where you stopped.
Stop
1.Press
the playback, "
2.Press
Adjusting volume
Press VOL+ or VOL- to change volume.
Skip
You can skip chapters on DVD-Video, tracks on CDs, and
Video CDs.
(on the player) to start 1.To skip forward, press
chapter or track. Each press increases the numbers of skips.
2.To skip to previous chapter or track, press
Fast Forward and Reverse
1.During playback, to fast forward, press and hold
player) to increase the fast forward speed 2x, then repeatedly
press
repeatedly press
fast forward speed.
2.During playback, to fast reverse, press and hold
player) to increase the fast reverse speed 2x ,then repeatedly
press
repeatedly press
fast reverse speed.
3.To resume normal playback, press
~ 14 ~
(on the remote or on the player) to temporarily stop
" appears on the screen.
again to stop the playback.
during play ,it skips to the next
to increase to 4x, 8x, 16x, 32x.You can also simply
on the remote control to increase the
to increase to 4x, 8x, 16x, 32x. You can also simply
on the remote control to increase the
.
.
(on the
(on the