Using The Battery Pack - LENCO DVP-1023 CR Manual

Using the Battery Pack

Installing the battery pack
<1>.Align and insert the battery <2>.Slide the battery pack to the
pack into the corresponding
slots on the back of the unit.
Charging the battery pack
1.Attach the battery pack to the Player.
2.Use the AC adapter to charge the battery pack. Make the connection as illustrated below.
3.Slide POWER to ON. ( The Player must be turned on to charge the battery).
LED Indicator
During charging, the red and green LEDs blink alternatively.
When the battery is fully charged, the orange LED stays lit .
When the Player uses battery for power, steady red LED lights.
If the battery power is low, the red LED blinks.
Removing the battery pack
<1>.Slide down the latch.
left until it clicks into place.
To DC12V IN on the DVD player
~ 12 ~
<2>.Slide the battery pack to the
right, and remove.
To home power outlet
LED INDICATOR
OPEN