Setting The Clock; Setting The Timer - Aiwa LCX-150 Operating Instructions Manual

SETTING THE CLOCK
m—
-m
When the AC cord is connected for the first time, the time on the
display flashes.
Set the time as follows
while the power is off.
1
2
3
4
5
Press the SET button.
The hour flashes.
Press the 1<+ or >[ button to designate
hour.
Press the SET button to set the hour.
The hour stops flashing and the minute starts flashing.
Press the l++ or >1 button to designate
minute.
the
the
Press the SET button to set the minute and
complete setting.
The minute stops flashing on the display and the clock starts
from 00 seconds.
To correct the current time
Press the POWER button to turn the unit off and press the SET
button. Then, carry out steps 1 to 5 above.
To display the current time
Keep the button pressed until the clock is displayed. The
time is displayed for 4 seconds,
To switch to the 24-hour standard
While the power is on, keep the button pressed until the clock
is displayed and then press the REPEAT button within 4 seconds.
Repeat the same procedure to restore the 12-hour standard.
If the clock display flashes while the power is off
This is caused by a power interruption, The current time needs
to be reset,
If power is interrupted for more than approximately 12 hours, all
settings stored in memory after purchase need to be reset.
SETTING THE TIMER
u
<—
c).
.— —----
'
1
The unit can be turned on at a specified time with the built-in
timer.
Preparation
Make sure the clock is set correctly.
1
2
3
4
5
Press the TIMER button on the remote control to
display 0, and press the SET button within z
seconds.
O
is displayed, and the hour flashes.
m
If you do not press the SET button within 2 seconds, another
operation may start.
Designate the hour of the timer-on time by
pressing the 1<+ or FPI button, and press the
SET button. Repeat to designate the minute of
the timer-on time.
Select the duration for the timer-activated period
with the l-or >1 button and press the SET
button.
The duration for the timer-activated period can be set between
5 and 240 minutes in 5-minute steps.
Prepare the source.
To listen to a CD, press the
-11
button and load the disc.
To listen to the radio, press the BAND button and tune in to
a station.
Press the POWER button to turn the unit off after
adjusting the volume.
@
remains on the display after the power is turned off (timer
standby mode).
When the timer-on time is reached, the unit turns on and
begins play with the selected source.
You cannot set the volume level to 21 or higher,
9
ENGLISH