INFOSEC UPS SYSTEM E3 PERFORMANCE RT 800 VA Manual page 37

2.5 Battery replacement
NOTICE: This UPS is equipped with internal batteries and user can replace the batteries
without shutting down the UPS or connected loads (hot-swappable battery design).
Replacement is a safe procedure, isolated from electrical hazards.
CAUTION! Consider all warnings, cautions, and notes before replacing batteries.
Note: Upon battery disconnection, equipment is not protected from power outages.

Step 1
Remove front panel.

Step 4
Remove the top cover of
battery box and replace the
inside batteries.

Step 7
2-6 Battery Kit Assembly (option)
NOTICE: Please assemble battery kit first before installing it inside of UPS. Please select
correct battery kit procedure below to assemble it.
INFOSEC UPS SYSTEM - 15, rue du Moulin - 44880 Sautron - FRANCE - www.infosec-ups.com
Hot Line – Tel + 33 (0)2 40 76 15 82 - Fax + 33 (0)240 94 29 51 - hotline@infosec.fr – 06 17 AA 59 205 11

Step 2
Disconnect battery wires.

Step 5
After replacing the
batteries, put the battery
box back to original
location and screw it
tightly.
Put the front panel back to the unit.

Step 3
Pull out the battery box by
removing two screws on the
front panel.

Step 6
Re-connect the battery wires.
37