Advertisement
3.
Make all power connections.
Connect a CS 5 PS 12
power supply to the DC
48V input on the Base
Unit rear panel.
If your system uses
more
than
twelve
microphone
stations,
connect another CS 5
PS 12 power supply.
Each
power
supply
powers
maximum
6
stations
left
and
six
stations right of the unit
you connect it to.
4.
Set
each
chairperson's
Voting
Station to PRESIDENT
mode
using dip switch 8 on the CS5VU (bottom side)
5. Power up the system
First power up all CS5PS12 set in the ring, then set the front panel POWER switch on the CS5BU to "I". The
yellow REMOTE and red NOM LEDs will start flashing. After a few seconds, the green POWER LED on the
Base Unit will be lit and the LCD backlighting on the microphone stations will come on. Blinking red lights on
the front of the CS5BU tell you that one or more cable connections in the system ring are not ok.
Microphones next to the problem source will blink – that makes it easy to find the loose connection.
6. Automatic Addressing = Learn the System
Coming from the factory each station has the same ID address.
To re-address all stations you have to learn the system (only at
the very first start up, or when you add or remove stations)!
Take the service card supplied with the CS5 BU and insert it into one
of the CS5VU stations (you need at least one in each system). The
display will tell you to press buttons 1+5 simultaneously. Do so. When
display shows "learning succeeded" you are ready to use the system.
Please download the manual from our home page
www.akg.com
for
more details.
If you would like to share your experience with us please write to us
under:
thomas.giczy@harman.com
AKG Acoustics GmbH A-1230 Wien, Lemböckgasse 21-25,
Tel.: +43-1-866 54-0, Fax: +43-1-866 54-8800
www.akg.com
Advertisement
