Invoking X Windows; Overview; Configuring X Windows; Single Screen Mode - Tech Source RAPTOR 1100T - DRIVERS FOR HP-UX INSTALLATION-REFERENCE Installation And Reference Manual

Raptor drivers for hp-ux
Table of Contents

Advertisement

INVOKING X WINDOWS

4.1 Overview

There are several ways to invoke X Windows on your system:
startx
xinit
Common Desktop Environment (CDE)
This section assumes the use of the csh environment. If you prefer
a different shell, make the appropriate changes from the examples.
All of the examples in this section use the device names /dev
/raptor0 and /dev/rap1kt0. Your device name may differ,
depending on the card type and instance number. Please refer to
Section 3.3 for specific device names.

4.2 Configuring X Windows

4.2.1 Single Screen Mode

Under HP-UX, the devices that X Windows will use are configured in
the file /etc/X11/X0screens. This file is used by the X Server
regardless of how it is invoked (e.g. startx, xinit, CDE, etc). Edit
the file /etc/X11/X0screens to configure display 0. For display
1 you would edit /etc/X11/X1screens.
This section assumes that display 0 is to be configured. To run X
Windows on the Raptor card only, comment out /dev/crt in
/etc/X11/X0screens by placing a ' # ' at the beginning of that
line,
and
add
the
/dev/raptor0 on a new line:
Chapter 4
Raptor
device
by
4-1
entering
Screen

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the RAPTOR 1100T - DRIVERS FOR HP-UX INSTALLATION-REFERENCE and is the answer not in the manual?

Table of Contents