Tech Source RAPTOR 1100T - DRIVERS FOR HP-UX INSTALLATION-REFERENCE Installation And Reference Manual page 19

Raptor drivers for hp-ux

Table of Contents

Enlarged version

installation, or if for some other reason the device nodes are not

created, or if any Raptor cards are added to or removed from the

system after the software has been installed, then the Raptor drivers

must be reconfigured in order to create the proper device nodes

under /dev (i.e. /dev/raptor0, /dev/rap2kt1, etc.). To

reconfigure the Raptor drivers, issue the following two commands:

On HP-UX 10.20:

For Raptor 2000 cards:

# swconfig

For Raptor 2100T, Raptor 1100T and Raptor 2500T-DL cards:

# swconfig

On HP-UX 11.0:

For Raptor 2000 cards:

# swconfig

For Raptor 2100T, Raptor 1100T and Raptor 2500T-DL cards:

# swconfig

On HP-UX 11i:

For Raptor 2100T, Raptor 1100T and Raptor 2500T-DL cards:

# swconfig

Chapter 3 - Software Installation

-u TSIRDHPUX_10

TSIRDHPUX_10

-u TSIFTHPUX_10

TSIFTHPUX_10

-u TSIRDHPUX_11

TSIRDHPUX_11

-u TSIFTHPUX_11

TSIFTHPUX_11

-u TSIFTHPUX_11i

TSIFTHPUX_11i

3-7

Table of Contents

Need help?

Do you have a question about the RAPTOR 1100T - DRIVERS FOR HP-UX INSTALLATION-REFERENCE and is the answer not in the manual?