Happy Plugs Air 1 Go Manual

CONNECT AND USE

1. Charge Air 1 Go for a least 15 minutes before use.
2. Remove the earbuds from the charge case. Keep them within 10 cm/4 inches apart from each other until the LED on the left earbud stops blinking.
3. Select "Air 1 Go" on your phone/device to pair.

When inserting the earbuds into your ears - make sure not to touch the touch control surface. A five second touch turns the earbud off.

RESET TO FACTORY SETTINGS

1. Delete "Air 1 Go" from your Bluetooth devices list.
2. Make sure the charge case is charged. Put the earbuds in the charge case.
3. Touch and hold the touch sensors on both earbuds for 10 seconds until the earphone LEDs blink 3 times.

The earbuds are now reset and ready to pair to your device. Just follow the quickstart steps.

CALLS

When using the Air 1 Go for phone calls, both earbuds are active, but only the right (R) earbud has a microphone for speaking.
On Apple devices, while your Air 1 Go is paired; go into Settings > Accessibility > Touch, scroll down to Call Audio Routing and select Bluetooth Headset.

SIRI OR GOOGLE ASSISTANT

Control calls and music with Siri or Google Assistant. On iPhone, go into Settings > Touch ID & Passcode, scroll down to Allow Access when locked and enable Siri.

TOUCH CONTROLS

	2 s	Power On
	5 s	Power Off
	10 s	Reset (In the case)
	× 1	Volume Up
	× 2	Volume Down
	× 1	Play / Pause
	× 2	Next Track
	× 3	Previous Track
	× 1	Call Answer / Call End
	× 2	Reject Call
	2 s	Switch Call
	2 s	Siri / Google Assistant

FAQ available at: help.happyplugs.com