Happy Plugs AIR 1 Manual

YOUR HAPPY PLUGS AIR 1

1. Air 1 Earbud
2. Air 1 Charge & Storage Case
3. Earbud Touch Control Sensor
4. Earbud LED
5. Microphone
6. Earbud Charge Cradle
7. Charging Pin
8. Charge Case LED
9. Charge Case Micro-USB Connection
10. Easy Opening Cut-Out

CONNECT AND USE

1. Activate Bluetooth on your phone or device.
2. Remove the Air 1 earbuds from the charge case, and select "Air 1 by Happy Plugs" on your phone/device to pair. Keep the earbuds within 20 cm / 7 inches apart from each other.
3. Insert the Air 1 earbuds into your ears. Adjust the angle to find your perfect fit.

When inserting the Air 1 into your ears - make sure not to touch the touch control surface. A four second touch turns the earbud off.

CHARGING THE CASE

Charge your Air 1 case by connecting the included Micro-USB cable to a USB power source. When the Air 1 case LED is turned on, the case is charging. When the light turns off your Air 1 case is fully charged.

CHARGING THE EARBUDS

To charge the Air 1 earbuds place them in the charging case. When the Air 1 earbud LED is turned on, the earbud is charging. Once the lights turns off you Air 1 earbud is fully charged.

LED GUIDE

The Air 1 earbuds & case LEDs are lit up while charging. When fully charged the light turns off. When removing the Air 1 from the case, the earbuds' LED will blink slowly while pairing to your bluetooth source and blink fast while connecting to each other.

CALLS

Using the Air 1 for phone calls, both earbuds are active, but only the right (R) earbud has dual microphones. This means that you need to use the right (R) earbud when using just one earbud for phone calls.

To get the most out of your new Air 1 when used together with an Apple Device; while your Air 1 is paired go into Settings > General > Accessibility, scroll down to Call Audio Routing and select Bluetooth Headset.

TOUCH CONTROLS

Both earbuds have a touch sensor (see illustration). Tap it with your finger to control your calls and music according to the guide.

SIRI OR GOOGLE ASSISTANT

Control your calls and music with Siri or Google Assistant by pressing 2 sec on right (R) earbud.

To use Siri on your iPhone while it is locked, go into Settings > Touch ID & Passcode, scroll down to Allow Access when locked and enable Siri.

RESET TO FACTORY SETTINGS

If you need to reset your earbuds and terminate any previous bluetooth pairing:

1. Touch the sensors on the left (L) and right (R) earbud for 5 consecutive seconds until they turn off.
2. Touch the sensors on the left (L) and right (R) earbud for 10 consecutive seconds until there is an audio signal in each earbud. The LEDs will turn off at this stage.
3. Place your earbuds in the Air 1 case until the LEDs turns on.
4. Take the earbuds out of the Air 1 case to initiate the pairing between left (L) and right (R) earbud. Keep the earbuds within 20 cm / 7 inches apart from each other.

TOUCH CONTROLS

Left (L) & Right (R) Earbud
Power On	Hold 2 Seconds
Power Off	Hold 4 Seconds
Power on + Reset	Hold 10 Seconds
Left (L) Earbud
Volume Up	Single Touch
Volume Down	Double Touch
Right (R) Earbud (Music Controls)
Play / Pause	Single Touch
Next Track	Double Touch
Previous Track	Triple Touch
Right (R) Earbud (Phone Call Controls)
Call Answer / Call End	Single Touch
Reject Call	Double Touch
Switch Call	Hold 2 Seconds
Right (R) Earbud
Siri / Google Assistant	Hold 2 Seconds

WARRANTY & SAFETY

LISTEN RESPONSIBLY
To avoid hearing damage, make sure that the volume on your music player is turned down before connecting your headphones. After placing the headphones in your ears, gradually turn up the volume until you reach a comfortable listening level.
Noise levels are measured in decibels (dB). Exposure to any noise at or above 85 dB can cause gradual hearing loss.

USE RESPONSIBLY
Do not use headphones when it's unsafe to do so such as while operating a vehicle, crossing streets, or during any activity or in an environment where your full attention to your surroundings is required.
It's dangerous to drive while wearing headphones, and in many places it's illegal because it decreases your chances of hearing life-saving sounds outside of your vehicle, such as another car's horn or emergency vehicle sirens.

SAFETY NOTICE

• The apparatus shall not be exposed to dripping or splashing and no objects filled with liquids, sush as vases, shall be placed on the apparatus.
• Danger of explosion if battery is incorrectly replaced. Replace only with the same or equivalent type.
• Batteries (battery pack or batteries installed) shall not be exposed to excessive heat such as sunshine, fire or similar.

REGUL ATORY COMPLIENCE INFORMATION

European Community

Disposal and Recycling Information
Your product must be disposed of properly according to local laws and regulations. When your product reaches its end of life, contact Happy Plugs or your local authorities to learn about recycling options.

European Union—Disposal Information
This symbol means that according to local laws and regulations your product and/or its battery shall be disposed of separately from household waste. When this product reaches its end of life, take it to a collection point designated by local authorities. The separate collection and recycling of your product and/or its battery at the time of disposal will help conserve natural resources and ensure that it is recycled in a manner that protects human health and the environment.

FCC Statement
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that may cause undesired operation.

NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device pursuant to Part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of following measures.

• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.

Changes or modifications not expressly approved by Happy Plugs AB could void the user's authority to operate the equipment.

Recycling
For detailed information about how to recycle this product, please contact your local recycling centre or store where you purchased the product.

Industry Canada Notice
For Your Attention
This device complies with Industry Canada license-exempt RSS standard(s). Operation is subject to the following two conditions:
(1) this device may not cause interference, and
(2) this device must accept any interference, including interference that may cause undesired operation of the device.

This Class B digital apparatus complies with Canada ICE-003.
CAN ICES-3(B)/NMB-3(B)
FCC ID: 2AJYS-AIR1
IC: 22014-AIR1

IC Radiation Exposure Statement:
This equipment complies with Canada radiation exposure limits set forth for uncontrolled environments. This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter.

Model name: Happy Plugs Air 1
Manufacturer: Happy Plugs AB, Kungsgatan 4B, 111 43 Stockholm, Sweden
Product name: Bluetooth Earphone
Model No.: 1616, 1617, 1618, 1619
Operating Frequency range: 2.4-2.48 GHz
Max output power: 4 dBm
SRD: 5.244 MHz
Maximum Radio-frequency Power transmitted <= 3.5 mW

EU Declaration of conformity
Hereby, Happy Plugs AB declares that the Happy Plugs Air 1 is in compliance with Directive 2014/53/EU and amendment 2015/863 of Directive 2011/65/EU. The full text of the EU declaration of conformity is available at the following internet address: help.happyplugs.com/

WARRANTY REGISTRATION
Register and upgrade to Happy Plugs Privilege Members Club now to enjoy our comprehensive warranty services and exclusive member benefits.
REGISTER.HAPPYPLUGS.COM

Videos

Happy Plugs AIR 1 - How To Reset Video

Happy Plugs AIR 1 - How To Get Started Video

Documents / Resources

References

• Happy Plugs

Download manual

Here you can download full pdf version of manual, it may contain additional safety instructions, warranty information, FCC rules, etc.

Download Happy Plugs AIR 1 Manual