Tikom G8000 Manual

Table of Contents

Contents

Tikom G8000 Manual

Getting Started

Notes:

Getting Started - Step 1

Notes:

Always keep the Charging Station plugged in, otherwise Robot will not automatically return
Remove objects within 3 ft/ 1 m of the left and right side and within 6 ft/2 m of the front of the Charging Station
Recommend to use provided adhesive tapes to fix charging station on the ground

Getting Started - Step 2

Notes: Please fully charge robot before use Manually align the Charging Contacts on the bottom the robot with those on the Charging Station

Please remove any objects from floor that may entangle robot vacuum, such as pet poop, socks, cloths, tissue, toys, slippery and power cords You can use supplied Cable Ties to organize your wires and power cords
Before using the robot on a rug with tasseled edges, please fold the rug edges under
Keep robot away from wet areas, such as kitchen or bathing room

The round base of some Bar Chairs, PedestaI Tables, PedestaI Fans and Floor Lamps which robot could climb onto will affect robot mapping & navigation So when robot cleaning, please remove these Bar Chairs, PedestaI Tables, PedestaI Fans and Floor Lamps with round base, or use supplied Boundary strip to block off problem areas
Keep robot away from spaces between 2.56in/65mm- -3.54in/90mm (Robot thickness is 3in/76 mm) to prevent robot from getting stuck, like sofa, cabinet or other furniture If necessary, you could use supplied Boundary Strip to block off the problem areas
Cliff sensors will prevent robot from tumbling down stairs and steep drops in most cases Cliff sensors are less effective if dirty or used on carpeted/ reflective / very dark-colored floors It's recommended to apply the provided Boundary Strip to block off are as where cliff sensors are less effective as described above
The Robot may not run on certain darker black colored surfaces since the Cliff Sensors that recognize an edge or a stair may regard black color as an edge, then the robot will not clean over it

Avoid cleaning high-pile rugs thicker than 0 78 in/ 20 mm, as they may cause Robot to malfunction
While your robot is cleaning, do not pick it up and move it, or move the charging station this could impact the robot's ability to map your home or back to charging station
To keep Robot away from any area or item you do not want Robot to clean, apply the supplied Boundary Strip on the floor with the supplied adhesive tape to create a virtual barrier Make sure the strips are placed FLAT on the floor

Notes:

Please Put Robot near Wi-Fi Router
Make sure your mobile phone is connecting with 2 4GHz Wi-Fi
If your router is 2 4GHz and 5GHz Dual band, please connect your mobile phone with 2 4GHz Wi-Fi
In your router, if 2 4GHz and 5GHz Wi-Fi use same Wi-Fi name, please enter router control page to rename 2 4GHz and 5GHz Wi-Fi with different Wi-Fi name Then make your mobile phone to connect with new 2 4GHz Wi-Fi

Search for TuyaSmart from App Store/GoogIe Play, or Scan above QR code to download APP
Register and log into the APP
Press and hold and buttons on the robot at the same time for 3 seconds, Robot will say 'Wi-Fi reset, ready for EZ mode connection", and Wi-Fi Status Light will Fast Flash.
Open TuyaSmart app, Tap "Add Device" or "+ at the upper right corner
Will appear this page, select "Go to add"
SeIect the same router's 2.4GHz Wi-Fi as mobile phone and enter the correct password Tap 'Next"

Connecting
Connection successful, and Robot will say "Wi-Fi Connection Successful and Wi-Fi Status light will be solid Tap"Next"
Connection Successfully