ELEQ LS-84 Installation Manual

Technical Specification
Technical Specification
Technical Specification
Safety and environmental conditions
Safety and environmental conditions
CE marking LV directive 2014/35/EU
Safety and environmental conditions CE marking LV directive 2014/35/EU
RoHS directive (EU) 2015/863
RoHS directive (EU) 2015/863
CE marking LV directive 2014/35/EU
WEEE directive 2012/19/EU
WEEE directive 2012/19/EU
RoHS directive (EU) 2015/863
Standard EN-IEC 61439-2:2011
Standard EN-IEC 61439-2:2011
WEEE directive 2012/19/EU
Standard EN-IEC 61439-2:2011
This product is designed to be safe under the following
This product is designed to be safe under the following
conditions:
conditions:
This product is designed to be safe under the following
conditions:
Specification
Specification
Environmental conditions
Environmental conditions
Specification
Operating temperature: -5 °C - +55 °C
Operating temperature: -5 °C - +55 °C
Environmental conditions
Relative humidity: 5% - 85%, non condensing
Relative humidity: 5% - 85%, non condensing
Operating temperature: -5 °C - +55 °C
Protection degree: IP23
Protection degree: IP23
Relative humidity: 5% - 85%, non condensing
Installation class: || (double insulation)
Installation class: || (double insulation)
Protection degree: IP23
Pollution degree: 2
Pollution degree: 2
Installation class: || (double insulation)
Application conditions
Application conditions
Pollution degree: 2
Umax:
Umax: 400 V
400 V
Application conditions
I :
I :
63 A (mantle terminals) 63 A (mantle terminals)
nA
nA
Umax:
400 V
Frequency:
Frequency: 50 Hz
50 Hz
I :
63 A (mantle terminals)
Fuse:
nA Fuse: 2 or 3x D01 (E14), max 16A
2 or 3x D01 (E14), max 16A
Frequency:
50 Hz
Strain relief:
Strain relief: Yes, maximum 2 ground cables
Yes, maximum 2 ground cables
Fuse:
2 or 3x D01 (E14), max 16A
23mm and 2 light poles cords
23mm and 2 light poles cords
Strain relief:
Yes, maximum 2 ground cables
Maximum wire cross section
Maximum wire cross section
Terminal N, 1, 2, 3: 2x 16mm Terminal N, 1, 2, 3: 2x 16mm
23mm and 2 light poles cords
and torque :
and torque : 4Nm
4Nm
Maximum wire cross section
Terminal N, 1, 2, 3: 2x 16mm
Terminal 4, 5, 6, 7: 2.5mm
Terminal 4, 5, 6, 7: 2.5mm
and torque :
4Nm
Diameter ø (mm)
Diameter ø (mm) 84
84
Terminal 4, 5, 6, 7: 2.5mm
279,5
Height (mm) 279,5
Height (mm)
Diameter ø (mm)
84
Storage
Storage
Height (mm) 279,5
Temperature: -20 °C - +70 °C
Temperature: -20 °C - +70 °C
Storage
Relative humidity: 5% - 85%, non condensing
Relative humidity: 5% - 85%, non condensing
Temperature: -20 °C - +70 °C
* Multi-wire flexible conductors must be assembled in ring-tongues,
* Multi-wire flexible conductors must be assembled in ring-tongues,
Relative humidity: 5% - 85%, non condensing
ferrules or wire pins.
ferrules or wire pins.
* Multi-wire flexible conductors must be assembled in ring-tongues,
ferrules or wire pins.
Specification per type
Specification per type
5L4162.. 5L4163..
5L4162.. 5L4163.. 5L4164..
Specification per type
Fuse
Fuse
2 x 6A 3 x 6A
2 x 6A 3 x 6A
included 5L4162.. 5L4163.. 5L4164..
included
Fuse PE-N
PE-N
2 x 6A No 3 x 6A No
No No
connection
included connection
Weight (gr)
PE-N Weight (gr)
560 570
560 No 570 No
connection
Weight (gr)
560 570
Please be aware, product liability, standards and warranty are all
Please be aware, product liability, standards and warranty are all
expired when modifications on the product are made.
expired when modifications on the product are made.
Please be aware, product liability, standards and warranty are all
expired when modifications on the product are made. ELEQ reserves the right to carry out modifications on its products, in
ELEQ reserves the right to carry out modifications on its products, in
order to improve them, without prior notice.
order to improve them, without prior notice.
ELEQ reserves the right to carry out modifications on its products, in
order to improve them, without prior notice.
Safety instruction
Safety instruction
Safety instruction
All activities for installation, commissioning and maintenance of
All activities for installation, commissioning and maintenance of
this connection box must be performed by qualified personnel
this connection box must be performed by qualified personnel
All activities for installation, commissioning and maintenance of
that has the knowledge of applicable safety precautions. This
that has the knowledge of applicable safety precautions. This
this connection box must be performed by qualified personnel
guide assumes that the reader of this document has sufficient
guide assumes that the reader of this document has sufficient
that has the knowledge of applicable safety precautions. This
electro-technical knowledge to understand the content of this
electro-technical knowledge to understand the content of this
guide assumes that the reader of this document has sufficient
document.
document.
electro-technical knowledge to understand the content of this
document.
General
General
General The LS-84 is a connection box for public lighting and intended
The LS-84 is a connection box for public lighting and intended
to be used in lighting poles. The connection box should be
to be used in lighting poles. The connection box should be
The LS-84 is a connection box for public lighting and intended
mounted in a weather protected and dry location. In the
mounted in a weather protected and dry location. In the
to be used in lighting poles. The connection box should be
connection box the incoming (ground) cable can be connected.
connection box the incoming (ground) cable can be connected.
mounted in a weather protected and dry location. In the
If desired, looped circuits wiring to the next lighting pole is
If desired, looped circuits wiring to the next lighting pole is
connection box the incoming (ground) cable can be connected.
possible. The cable of the armature should be connected on possible. The cable of the armature should be connected on
If desired, looped circuits wiring to the next lighting pole is
the outgoing terminals.
the outgoing terminals.
possible. The cable of the armature should be connected on
the outgoing terminals.
Fuses protect the installation against overload and short-
Fuses protect the installation against overload and short-
circuiting. circuiting.
Fuses protect the installation against overload and short-
circuiting.
Explanation of symbols
Explanation of symbols
Explanation of symbols
2 , 2-
2 , 2-
2 , 2-
2 1-2Nm*
2 1-2Nm*
2 1-2Nm*
5L4164.. 5L4165..
5L4165..
3 x 2A 2 x 2A
3 x 2A 2 x 2A
5L4165..
3 x 2A No 2 x 2A No
No No
570 560
570 No 560 No
570 560
ELEQ b.v.
Tukseweg 130, 8331 LH Steenwijk, The Netherlands
+31 (0) 521 533 333
This product is designed according
This product is designed according
EN-IEC 61439-2:2011 standards and meets the
EN-IEC 61439-2:2011 standards and meets the
This product is designed according
requirements of the Low Voltage Directive 2014/35/EU.
requirements of the Low Voltage Directive 2014/35/EU.
EN-IEC 61439-2:2011 standards and meets the
requirements of the Low Voltage Directive 2014/35/EU.
Read the installation guide before mounting the
Read the installation guide before mounting the
product. Unprofessional work activities on electrical
product. Unprofessional work activities on electrical
Read the installation guide before mounting the
installations may result in a threat of danger to the life
installations may result in a threat of danger to the life
product. Unprofessional work activities on electrical
and health of human beings and livestock!
and health of human beings and livestock!
installations may result in a threat of danger to the life
and health of human beings and livestock!
RoHS Directive (EU) 2015/863 RoHS Directive (EU) 2015/863
ELEQ states that it uses qualified components in its
ELEQ states that it uses qualified components in its
RoHS Directive (EU) 2015/863 products only from manufacturers which meet the
products only from manufacturers which meet the
requirements of the European Directive for the
requirements of the European Directive for the ELEQ states that it uses qualified components in its
"Restriction of use of certain Hazardous Substances
"Restriction of use of certain Hazardous Substances products only from manufacturers which meet the
requirements of the European Directive for the
"Restriction of use of certain Hazardous Substances
WEEE Directive 2012/19/EU
WEEE Directive 2012/19/EU
This equipment should not be disposed as unsorted
This equipment should not be disposed as unsorted
municipal waste. Contact a qualified recycler for
municipal waste. Contact a qualified recycler for WEEE Directive 2012/19/EU
disposal.
disposal.
This equipment should not be disposed as unsorted
municipal waste. Contact a qualified recycler for
disposal.
83969
83969
info@eleq.com www.eleq.com
83969 / EN2407
LS-84 Connection Box for
LS-84 Connection Box for
LS-84 Connection Box for
Public Lighting
Public Lighting
Public Lighting
Installation Guide
Installation Guide
Installation Guide
to the
to the
to the
LS-84
LS-84
LS-84
Read this installation guide before installing the product
Read this installation guide before installing the product
Read this installation guide before installing the product
ELEQ b.v.
Tukseweg 130, 8331 LH Steenwijk, The Netherlands
v
v
/ EN2407
/ EN2407
+31 (0) 521 533 333 info@eleq.com
5L4163
5L4163
5L4163
5L4162 ..
5L4162 ..
5L4163..
5L4163..
5L4162 ..
5L4164..
5L4164..
5L4163..
5L4165..
5L4165..
5L4164..
5L4165..
www.eleq.com