ELEQ LS-94 Installation Manual

Technical Specification

Technical Specification
Technical Specification

Safety and environmental conditions

Safety and environmental conditions
Safety and environmental conditions
CE marking LV directive 2006/95/EC
CE marking LV directive 2006/95/EC
CE marking LV directive 2006/95/EC
RoHS directive 2011/65/EU
RoHS directive 2011/65/EU
RoHS directive 2011/65/EU
WEEE directive 2012/19/EU
WEEE directive 2012/19/EU
WEEE directive 2012/19/EU
EN-IEC 61439-2:2011
EN-IEC 61439-2:2011
Standard EN-IEC 61439-2:2011
Standard
Standard EN-IEC 60269-3:2013
EN-IEC 60269-3:2013
EN-IEC 60269-3:2013
This product is designed to be safe under the following
This product is designed to be safe under the following
This product is designed to be safe under the following
conditions:
conditions:
conditions:
Specification
Specification
Specification
Environmental conditions
Environmental conditions Environmental conditions
Operating temperature: -5°C - +55°C
Operating temperature: -5°C - +55°C
Operating temperature: -5°C - +55°C
Relative humidity: 5% - 85%, non condensing
Relative humidity: 5% - 85%, non condensing
Relative humidity: 5% - 85%, non condensing
Protection degree: IP23
Protection degree: IP23
Protection degree: IP23
Installation class: 1 (protective earth)
Installation class: 1 (protective earth)
Installation class: 1 (protective earth)
Pollution degree: 2
Pollution degree: 2
Pollution degree: 2
Application conditions
Application conditions
Application conditions
Umax:
Umax: 230V (L-N)
Umax: 230V (L-N)
230V (L-N)
Frequency:
Frequency: 50Hz
Frequency: 50Hz
50Hz
Imax: Imax:
Imax: 25A (mantle terminals)
25A (mantle terminals) 25A (mantle terminals)
Fuse:
Fuse: 1x DII (E27), max 6A
Fuse: 1x DII (E27), max 6A
1x DII (E27), max 6A
Strain relief:
Strain relief:
Strain relief: Yes, maximum 2 ground cables Yes, maximum 2 ground cables
Yes, maximum 2 ground cables
23mm and 2 light poles cords 23mm and 2 light poles cords
23mm and 2 light poles cords
Maximum wire cross section Maximum wire cross section
Maximum wire cross section
and torque:
and torque: and torque:
Terminal N, 1, 2, 3: 2x 10mm Terminal N, 1, 2, 3: 2x 10mm Terminal N, 1, 2, 3: 2x 10mm
4Nm 4Nm
4Nm
Terminal 4, 5: 2,5mm
Terminal 4, 5: 2,5mm Terminal 4, 5: 2,5mm
Terminal 6, 7: 1,5mm
Terminal 6, 7: 1,5mm Terminal 6, 7: 1,5mm
Diameter ø
Diameter ø 94mm
Diameter ø 94mm
94mm
Height 279,5mm
Height Height 279,5mm 279,5mm
Storage
Storage Storage
Temperature: -20°C - +70°C
Temperature: -20°C - +70°C
Temperature: -20°C - +70°C
Relative humidity: 5% - 85%, non condensing
Relative humidity: 5% - 85%, non condensing
Relative humidity: 5% - 85%, non condensing
Approval Approval - -
Approval -
Specification per type
Specification per type
Specification per type
5L2411
5L2411
5L2411
Fuse included
Fuse included
Fuse included
Phase selection
Phase selection
Phase selection
PE-N connection
PE-N connection
PE-N connection
Covered mantle
Covered mantle
Covered mantle
terminals
terminals
terminals
Weight Weight 597gr
Weight 597gr
Citel MLPC1-230L-R*
Citel MLPC1-230L-R*
Surge Protection Citel MLPC1-230L-R*
Surge Protection
Surge Protection Protection level 10kA/10kV
Protection level 10kA/10kV
Device (SPD) Protection level 10kA/10kV
Device (SPD)
Device (SPD) Spring terminal connection for max 1,5mm²
Spring terminal connection for max 1,5mm²
Spring terminal connection for max 1,5mm²
* Please consult www.citel.fr for more information about the MLPC1- 230L-R
* Please consult www.citel.fr for more information about the MLPC1- 230L-R
* Please consult www.citel.fr for more information about the MLPC1- 230L-R
Please be aware, product liability, fulfilment to requirements and
Please be aware, product liability, fulfilment to requirements and
Please be aware, product liability, fulfilment to requirements and
warranty are all expired when modifications on the product are made.
warranty are all expired when modifications on the product are made.
warranty are all expired when modifications on the product are made.
ELEQ reserves the right to carry out modifications on its products, in
ELEQ reserves the right to carry out modifications on its products, in
ELEQ reserves the right to carry out modifications on its products, in
order to improve them, without prior notice.
order to improve them, without prior notice.
order to improve them, without prior notice.

Safety instruction

Safety instruction
Safety instruction
All activities for installation, commissioning and maintenance of
All activities for installation, commissioning and maintenance of
All activities for installation, commissioning and maintenance of
this connection box must be performed by qualified personnel
this connection box must be performed by qualified personnel
this connection box must be performed by qualified personnel
that has the knowledge of applicable safety precautions. This
that has the knowledge of applicable safety precautions. This
that has the knowledge of applicable safety precautions. This
guide assumes that the reader of this document has sufficient
guide assumes that the reader of this document has sufficient
guide assumes that the reader of this document has sufficient
electro-technical knowledge to understand the content of this
electro-technical knowledge to understand the content of this
electro-technical knowledge to understand the content of this
document.
document.
document.

General

General General
The LS-94 is a connection box for public lighting and intended
The LS-94 is a connection box for public lighting and intended
The LS-94 is a connection box for public lighting and intended
to be used in lighting poles. The connection box shall be
to be used in lighting poles. The connection box shall be
to be used in lighting poles. The connection box shall be
mounted in a weather protected and dry location. In the
mounted in a weather protected and dry location. In the
mounted in a weather protected and dry location. In the
connection box the incoming (ground) cable can be connected.
connection box the incoming (ground) cable can be connected.
connection box the incoming (ground) cable can be connected.
If desired, looped circuits wiring to the next lighting pole is
If desired, looped circuits wiring to the next lighting pole is
If desired, looped circuits wiring to the next lighting pole is
possible. The cable of the armature shall be connected on the
possible. The cable of the armature shall be connected on the possible. The cable of the armature shall be connected on the
outgoing terminals.
outgoing terminals.
outgoing terminals.
Fuses protect the installation against overload and short-
Fuses protect the installation against overload and short-
Fuses protect the installation against overload and short-
circuiting.
circuiting. circuiting.

Explanation of symbols

Explanation of symbols
Explanation of symbols
2 , 2- 2 , 2-
2 , 2-
2 , 1-2Nm
2 2 , 1-2Nm , 1-2Nm
2 , spring
2 2 , spring , spring
No
No
No
Yes
Yes
Yes
No
No
No
Yes
Yes
Yes
597gr
ELEQ b.v.
Tukseweg 130, 8331 LH Steenwijk, The Netherlands
+31 (0) 521 533 333
This This product product is is designed designed according according
This product is designed according
EN-IEC 61439-2:2011 standards and meets the
EN-IEC 61439-2:2011 standards and meets the EN-IEC 61439-2:2011 standards and meets the
requirements of the Low Voltage Directive 2006/95/EC. requirements of the Low Voltage Directive 2006/95/EC.
requirements of the Low Voltage Directive 2006/95/EC.
Read the installation guide before mounting the
Read the installation guide before mounting the Read the installation guide before mounting the
product. Unprofessional work activities on electrical product. Unprofessional work activities on electrical
product. Unprofessional work activities on electrical
installations may result in a threat of danger to the life
installations may result in a threat of danger to the life installations may result in a threat of danger to the life
and health of human beings and livestock!
and health of human beings and livestock! and health of human beings and livestock!
RoHS Directive 2011/65/EU
RoHS Directive 2011/65/EU
RoHS Directive 2011/65/EU
ELEQ states that it uses qualified components in its
ELEQ states that it uses qualified components in its
ELEQ states that it uses qualified components in its
products only from manufacturers which meet the
products only from manufacturers which meet the
products only from manufacturers which meet the
requirements of the European Directive for the
requirements of the European Directive for the
requirements of the European Directive for the
"Restriction of use of certain Hazardous Substances
"Restriction of use of certain Hazardous Substances
"Restriction of use of certain Hazardous Substances
WEEE Directive 2012/19/EU
WEEE Directive 2012/19/EU
WEEE Directive 2012/19/EU
This equipment should not be disposed as unsorted
This equipment should not be disposed as unsorted
This equipment should not be disposed as unsorted
municipal waste. Contact a qualified recycler for
municipal waste. Contact a qualified recycler for
municipal waste. Contact a qualified recycler for
disposal.
disposal.
disposal.
83751 / EN1603
83751 / EN1603
83751 / EN1603
info@eleq.com www.eleq.com
83751 / EN1603
LS-94 Connection Box for
LS-94 Connection Box for
LS-94 Connection Box for
Public Lighting
Public Lighting
Public Lighting
Installation Guide
Installation Guide
Installation Guide
to to the the
to the
LS-94
LS-94
LS-94
Read this installation guide before installing the product
Read this installation guide before installing the product
Read this installation guide before installing the product
ELEQ b.v.
Tukseweg 130, 8331 LH Steenwijk, The Netherlands
+31 (0) 521 533 333 info@eleq.com
5L2411
5L2411
5L2411
www.eleq.com