Clock And Timer; Setting The Clock; Setting The Sleep Timer - Aiwa DINA Z-A60 Operating Instructions Manual

CLOCK AND TIMER

SETTING THE CLOCK

1
s
a
f,g
2
3
When the clock is set, the ":" between the hours and minutes
flashes. When the power cord is plugged into an AC outlet for
the first time after purchase or when the clock setting is canceled
due to a power failure, the entire clock display flashes.
1 Press CLOCK.
When using the remote control, press CLOCK while pressing
SHIFT.
"AM 12.00" will be displayed.
2 Within 4 seconds, turn MULTI JOG to designate
the hour and the minute.
Turning MULTI JOG changes both the hour and the minute.
f or g is also available instead of MULTI JOG. Holding
these buttons down will vary the time rapidly.
3 Press ENTER or a.
The clock starts from 00 seconds.
To view the clock when another display is in the display
Press CLOCK. The time is displayed for 4 seconds and then the
original display reappears. However, the clock cannot be
displayed during recording.
To switch to the 24-hour standard
Press CLOCK and then press s within 4 seconds.
Repeat the same procedure to restore the 12-hour standard.
If the clock display flashes
If the display flashes when the clock is displayed, it indicates
that the clock has stopped due to a power failure or the
removal of the power cord. The current time needs to be reset.
NOTE
If the power-economizing mode (page 6) is on, all the display
lights turn off when the power is turned off. To view the clock,
press CLOCK so that the time is displayed for 4 seconds.

SETTING THE SLEEP TIMER

2
CLOCK
SHIFT
f,g
f,g
s
a
The unit can be turned off automatically at a specified time.
1 Press SLEEP while pressing SHIFT on the remote
control.
"SLEEP" appears on the display.
2 Within 4 seconds, turn MULTI JOG or press f
or g to specify the time until the power is
turned off.
The time changes between 5 to 240 minutes in 5-minute steps.
To check the time remaining until the power turns off
Press SLEEP once while pressing SHIFT. The remaining time is
displayed for 4 seconds.
To cancel the sleep timer
Press SLEEP twice while pressing SHIFT so that "SLEEPoFF"
appears on the display.
1
f,
g
En
15
ENGLISH