Light4Me SPARK LITE User Manual page 7

Safety rules
 The generator must be at least 100 cm away from combustible materials such as curtains,
books, etc.
 Use only the consumable material recommended by the distributor.
 Make sure nothing touches the housing during use.
 Indoor use only.
 During installation, no one should be below the installation point.
 Before first use, the device should be checked by a qualified person.
 There are live parts inside the device. DO NOT OPEN THE GENERATOR.
 Never plug and unplug the device with wet hands.
 If the plug or cable is damaged, it should be replaced or repaired by qualified personnel.
 If the device is damaged, or internal components are visible, do not connect the generator to the
mains. It must be repaired by a specialist.
 Always connect to a grounded power source of the correct voltage.
 Disconnect the generator from the mains during a storm.
 If the generator has not been used for a long time, wait until the device reaches room tempera-
ture before using it again.
 When disconnecting from the mains, always pull the plug, never the cord.
 In order to prevent the generator from falling when hanging, install safety handles. This can be
a chain or steel rope.
 The bracket is the basic mounting part and must be fixed firmly.
 To avoid danger or accident, all safety precautions must be followed.
 Keep away from children.
Operation
1. Before using the device, place the consumable material (not included) in the device tank.
2. The device need to be connected to the mains using the included power cable, but make sure that
the power source and the generator are grounded before connecting.
3. Before starting the device, you can connect a DMX cable to the device to control the operation of
the generator via DMX protocol – in this case, control with a wireless remote control will be disabled.
4. The device is started by turning the power switch to the ON position.
5. Wait a few minutes for the device to heat up before operating it.
6. Operation of the device is done:
 manually – the device is operated using 4 function buttons located under the LED display:
o MENU – selecting between menu options;
o ENTER – conforming and saving the option shown on the screen;
o UP – increasing the value of the option shown on the display;
o DOWN – decreasing the value of the option shown on the display;
Instrukcja obsługi / User Manual
6
LIGHT4ME SPARK LITE