Spanning-Tree Link-Type - SMC Networks TigerSwitch SMC6128PL2 Management Manual

forwarding should only be enabled for ports connected to a LAN
segment that is at the end of a bridged LAN or for an end-node
device.)
• This command is the same as spanning-tree edge-port, and is only
included for backward compatibility with earlier products. Note that
this command may be removed for future software versions.
Example
Console(config)#interface ethernet 1/5
Console(config-if)#bridge-group 1 portfast
Console(config-if)#
Related Commands
spanning-tree edge-port (4-208)

spanning-tree link-type

This command configures the link type for Rapid Spanning Tree and
Multiple Spanning Tree. Use the no form to restore the default.
Syntax
spanning-tree link-type {auto | point-to-point | shared}
no spanning-tree link-type
- auto - Automatically derived from the duplex mode setting.
- point-to-point - Point-to-point link.
- shared - Shared medium.
Default Setting
auto
Command Mode
Interface Configuration (Ethernet, Port Channel)
Command Usage
• Specify a point-to-point link if the interface can only be connected to
exactly one other bridge, or a shared link if it can be connected to two
or more bridges.
• When automatic detection is selected, the switch derives the link type
from the duplex mode. A full-duplex interface is considered a
point-to-point link, while a half-duplex interface is assumed to be on
4-210