Sabre HS-RL-EDA, HOME Series Manual

Also See for HOME Series:

User manual

Installation manual

Quick start manual (2 pages)

Table of Contents

Contents

1 INTRODUCTION
2 PARTS AND FEATURES
3 INSTALLING BATTERIES
4 OPERATION
5 TESTING
6 BATTERIES
7 Documents / Resources
- 7.1 References
- 7.2 Download manual

Sabre HS-RL-EDA, HOME Series Manual

INTRODUCTION

The alarm is operated using a 4-digit PIN code with the keypad located on the front of the alarm. The system has 3 operating modes: CHIME, ALARM/AWAY and ALARM/ HOME mode. CHIME mode is a low security feature that will produce a door-chime sound when the alarm is triggered in HOME or AWAY mode. In ALARM/AWAY mode the device will produce a constant high volume alarm sound after ENTRY delay, when triggered. In ALARM/HOME mode, the unit will produce a constant high volume alarm sound IMMEDIATELY after it is triggered.

These instructions should be kept in a safe place for future reference.

PARTS AND FEATURES

INSTALLING BATTERIES

The keypad controlled door alarm requires 3xAAA alkaline batteries (not included).

Remove the screw from the battery compartment cover located on the back of the unit. Slide off the door in the direction of the arrow.
Insert 3xAAA batteries noting the polarity diagram inside the battery compartment.
Replace the battery compartment cover and secure the screw.

OPERATION

Chime Mode

In Chime mode, the main unit will sound "Di-Do" when someone opens the door.

Setting Code

Open the battery compartment and press the LEARN button, the indicator light will flash red. Now, enter a 4-digit code, the indicator light will flash green 3 times to indicate that code setting is successful. The time limit of setting code is about 15 seconds.

Arming Setting

In ALARM mode, slide the switch to AWAY or HOME position and then enter the 4-digit code. The indicator light will flash green once to indicate that arming setting is successful. However, if the code entered is incorrect, the unit will sound a long "Di" and the indicator light will quickly flash red 3 times to indicate that arming setting failed. Enter the correct code to try again.

Disarming the Alarm

Under arming status, enter the 4-digit code, the unit will sound "Di-Di" and at the same time the indicator light will quickly flash green twice to indicate that disarming is successful.

Home Mode

In HOME mode, the alarm will immediately sound when the door is opened.

Away Mode

In AWAY mode, after arming, the indicator light will glow green constantly and enter to the mode selection status. The mode selection status will last for 5 seconds. Within the 5 seconds, press the corresponding number to select the mode you desired. See below for details. If timed out, it will return to the previous mode.

Number Key	Exit Delay	Entry Delay
	10S	5S
	15S	10S
	30S	15S
	45S	30S

During delay, the indicator light will flash red. "Exit Delay" allows time for you to leave the protected area without triggering the alarm and "Entry Delay" allows time to enter 4-digit code when entering to the protected area without triggering the alarm.

Panic Mode

In any case, press the number keys "1" and "4" at the same time, the alarm will immediately sound. In case of sounding an alarm, enter the 4-digit code to turn off the alarm sound and disarm at the same time.

Low Battery Indicator

When the battery voltage is low, the red LED light will flash once every 4s. In this situation, the user should replace batteries asap.

TESTING

It is recommended that the alarm is tested immediately after installation and at regular intervals not exceeding 1 month. Note: A cloth can be used to cover the siren and reduce the sound output of the alarm during testing.

BATTERIES

Do not allow the batteries to corrode and leak as this may cause permanent damage to the product. Take care to insert the batteries with the correct polarity as shown inside the battery compartment. Do not mix new and old batteries or different types of batteries. Do not use rechargeable batteries.

At the end of their useful life, the batteries should be disposed of via a suitable recycling center. Do not dispose of with your normal household waste. DO NOT BURN.

RISK OF PERSONAL INJURY PROLONGED EXPOSURE TO THE ALARM SIREN MAY CAUSE PERMANENT HEARING LOSS FOR INDOOR USE ONLY DO NOT USE IN WET LOCATIONS