Roland S-4000S Owner's Manual page 42

6—Using the S-4000 System
Recessed Rack-Mounting: S-4000S
Use the following procedure to remove and reinstall the S-4000S's rack-mount brackets for recessed
rack-mounting.
1. Turn off the power on all equipment and disconnect all cables from the S-4000S unit.
2. Remove only the screws shown in the following diagram (12 screws total), and detach the rack-
mount bracket from one side of the unit as shown.
3. Using the 12 screws you removed in Step 2, reinstall the rack-mount bracket as shown. (Note
that 8 screws are used to secure the rack-mount bracket, and 4 screws are reinstalled along the
rear edge of the side panel.)
4. Repeat Steps 2 and 3 to remove and reinstall the rack-mount bracket on the other side of the
unit.
42 S-4000 Digital Snake Owner's Manual