Brondell LumaWarm L60-EW / L60-EB - Heated Nightlight Toilet Seat Manual

Specifications

Parts List

This manual contains important safety information.
Please read it carefully before product installation or use.

Before Installation

Items required but NOT included: Screwdriver, wrench.
Be sure that all parts are on hand before proceeding with the installation.
Under normal circumstances, tools are not required for the installation process.
However, some toilet bowls may be designed with hard to reach areas, in which case, a screwdriver and wrench may be required.

Installation

Please read these instructions carefully before installing the LumaWarm.
Failure to do so may result in damage to the product

Removing Existing Toilet Seat

1. Lift hinge covers and use a screwdriver to remove the mounting bolts
2. Remove the toilet seat.

Steps may vary by type of seat.

Installing the LumaWarm

1. Rubber Washer
2. Plastic Washer
3. Plastic Wing-nut

1. Insert the adjustable Mounting Bolts into appropriate grooves on the bottom of the LumaWarm (US for United States & EU for European).
2. Insert the Mounting Bolts through the toilet mounting holes
3. Adjust the seat by sliding it forward or backward along the track to obtain optimum position over the toilet bowl
4. Insert Rubber Washer, Plastic Washer and Plastic Wing-nut, from under the toilet, onto each Mounting Bolt and fasten until snug (repeat process on the other side)
5. Use the Wrench to assist with tightening the Plastic Wing-nut if necessary.

Installing the LumaWarm (alternate)

Some toilet fixtures are designed with only top-side access. To install the LumaWarm onto these types of fixtures, an Alternate Mounting Kit is required.

To get a set of the Alternate Hardware, order online at www.brondell.com or call 1-888-542-3355

Plugging In the LumaWarm

1. Plug into a grounded GFCI outlet.
   
   
   Only use a grounded GFCI outlet

Operation

Seat Temperature Setting

To adjust seat temperature, gently press the button. Each time the button is pressed, a red LED will be lit, representing a higher level of temperature.

Temp. adjustment cycle: off / Low / Mid / High

Nightlight Setting

Turn the nightlight on/off by pressing the "light" button .

Maintenance

Always unplug the LumaWarm before cleaning!

Seat Cleaning

Use a soft, damp cloth and mild cleanser (such as dish soap) to wipe down the seat and lid. NEVER scrub or use harsh, abrasive products to clean the LumaWarm.

For more thorough cleaning, you may remove the LumaWarm. To release, unscrew and remove the Plastic Wing-nut, Plastic Washer and Rubber Washer that are against the bottom of the toilet mounting holes.

Perform the reverse operation when re-installing the LumaWarm back onto the toilet.

Troubleshooting

How to Obtain Service
For other issues or questions please visit our website: www.brondell.com
or contact Brondell Customer Service: 1-888-542-3355
E-mail support@brondell

Product Registration
To ensure you receive important warranty and product information, please register on-line at: http://www.brondell.com/warranty, within 10 days of purchase.

IMPORTANT SAFEGUARDS

GROUNDING INSTRUCTIONS

This product should be grounded. In the event of an electrical short circuit, grounding reduces the risk of electric shock by providing an escape wire for the electric current. This product is equipped with a cord having a grounding wire with a grounding plug. The plug must be plugged into a 120V GFCI outlet that is properly installed and grounded.

Improper use of the grounding plug can result in the risk of electric shock. If repair or replacement of the cord or plug is necessary, do not connect the grounding wire to either flat blade terminal. The wire with insulation having an outer surface that is green with or without yellow stripes is the grounding wire.

Check with a qualified electrician or serviceman if the grounding instructions are not completely understood, or if in doubt as to whether the product is properly grounded.

If it is necessary to use an extension cord, use only a three wire extension cord that has a three-blade grounding plug, and a three-slot receptacle that will accept the plug on the product. Replace or repair a damaged cord.

IMPORTANT SAFETY INSTRUCTIONS
When using electrical products, especially when children are present, basic safety precautions should always be followed, including the following:

READ ALL INSTRUCTIONS BEFORE USING

To reduce the risk of electrocution:

1. Do not use while bathing.
2. Do not place or store product where it can fall or be pulled into a tub or tank.
3. Do not place in or drop into water or other liquid.
4. Do not reach for a product that has fallen into water. Unplug immediately.

To reduce the risk of burns, electrocution, fire, or injury to persons:

1. Close supervision is necessary when this product is used by, on, or near children or invalids.
2. Use this product only for its intended use as described in the owner's manual. Do not use attachments not recommended by the manufacturer.
3. Never operate this product if it has a damaged cord or plug, if it is not working properly, if it has been dropped or damaged, or dropped into water. Return the product to a service center for examination and repair.
4. Keep the cord away from heated surfaces.
5. Never use while sleepy, drowsy, intoxicated, or under the influence of medication that may affect your judgement.
6. Never drop or insert any object into any opening or hose.
7. Do not use outdoors or operate where aerosol (spray) products are being used or where oxygen is being administered.
8. Connect this product to a properly grounded GFCI outlet only. See Grounding Instructions.

SAVE THESE INSTRUCTIONS

INFORMATION TO THE USERS

Any changes or modifications not expressly approved by the manufacturer could void the user's authority to operate the equipment and void warranty.

For safety reasons, please read this entire manual before use.

Possibility of Electric Shock! Use the correct voltage according to the Specifications and connect to a three prong GFCI grounded outlet.	Do not use harsh brushes or abrasive detergents to clean the LumaWarm. Use only mild soap and a soft cloth for cleaning.
Please use caution not to spray water directly on the LumaWarm. This could cause serious damage to the product, and may result in electric shock or fire.	Do not disassemble or modify the LumaWarm. Only an authorized service representative should perform repairs.
When not in use for a long period of time, plug out and keep the power cord in good condition not to cause any damage.

Documents / Resources

References

• Bidet Toilet Seats, Air Purifiers, Reverse Osmosis, Water Filters | Brondell

Download manual

Here you can download full pdf version of manual, it may contain additional safety instructions, warranty information, FCC rules, etc.

Download Brondell LumaWarm L60-EW / L60-EB - Heated Nightlight Toilet Seat Manual