Y-Volution FLIKER CARVER C5, FLIKER C5 - Scooter Manual

IMPORTANT NOTICE TO PARENTS

This manual contains important information relating to your child's safety, it is your responsibility to review this information with your child and make sure they are fully aware of all the information and warnings within the manual. Please carefully read this manual before you commence assembly of this scooter and review this information with young riders before they ride.

NOTE: Please read this manual carefully and keep it for future reference. The dealer will not take responsibility if the scooter is used in a manner for which is was not intended or if any warnings which are stated in the manual are not followed.

How to use and stop:
Move your hips and legs from side to side (just like downhill skiing) to get going and keep moving using body power. To stop, press the handbrake located on the handelbar.

Like any moving product, scooters can be dangerous if due care and attention is not paid. Be sure to read the manual before going on your scooter. In particular pay attention to the following:

1. Read the instructions carefully before using the scooter. Read the information supplied by the manufacturer.
2. User's Maximum weight: 100 kg for class A
3. Always wear safety equipment such as a helmet, knee pads and elbow pads.
4. Always wear a helmet when riding your scooter and keep chinstrap securely buckled.
5. Always wear closed toe shoes when riding. Wear personal protective equipment.
6. Avoid streets and surfaces with water, sand, gravel, dirt, leaves, and other debris. Wet weather impairs traction, braking and visibility.
7. Avoid sharp bumps, drainage grates and sudden surface changes. Scooter may suddenly stop.
8. Ride on smooth, paved surfaces away from motor vehicles.
9. Not to be used on public highways or in traffic.
10. Watch out for pedestrians
11. Check the limitation of use according to regulations of road safety. Obey all local traffic and scooter riding laws and regulations.
12. Avoid excessive speed associated with downhill rides.
13. Do not use the scooter at night or in periods with reduced visibility.
14. Before every use, please make sure that the scooter and all joints have been assembled tightly, as with use, joints may wear out.
15. Before using the scooter, please check that the screws are tightened securely.
16. Do not modify the product other than manufacturer's instructions. No modification that may reduce the scooter's safety is allowed.
17. Brake will get hot from continuous use. Do not touch after braking.
18. Periodically check hardware and tighten if necessary. Replace worn or broken parts immediately.
19. Skill is required to avoid falls or collision causing injury to the user and third parties.
20. Do not let children under the age of 9 use the scooter. Children under the age of 10 should ride with adult supervision at all times.
21. Do not perform stunts.
22. Ensure that any loose clothing or straps are properly fastened and well away from the front and rear wheels
23. While using the product, keep hands and fingers away from wheels and other moving parts to avoid danger of pinching or entrapment.
24. Adults must assist children in the initial adjustment procedures to unfold scooter, adjust handlebar and steering to height, and finally to fold scooter.
25. Self-locking nuts and other self-locking fixings may lose their effectiveness.
26. Check that the steering mechanism is correctly adjusted and that the connective components are firmly secured and not broken.

ASSEMBLY

RIDING YOUR PRODUCT

CARING FOR YOUR PRODUCT

1. After you have used the scooter for a week or two, the wheels will need to be checked to ensure they are still in perfect working order. To do so rotate the bearings and wheels and check if any lubrication or adjustments are needed.
2. DO NOT use a wet cloth, alcohol, industrial cleaners or solvents to clean the scooter as this may result in loss of gloss, the removal of decals or dissolve the materials in the scooter. If the scooter loses its gloss a small bit of car wax can be used to polish the scooter.
3. In normal circumstances it is recommended that you disassemble, clean and lubricate the scooter every 6 months. Please take extreme care to ensure the scooter is reassembled correctly.
4. If the front fork, wheels and/or rear support frame are not correctly tightened you can use a wrench to tighten the bolts correctly. Please ensure to not over or under tighten the bolts.
5. Due to normal wear and tear the wheels and bearings may need to be replaced after some time. Please contact Yvolution (www.yvolution.com) for new wheels. DO NOT use parts designed for other scooters, the use of anything other than Fliker parts may affect your safety.
6. If the brake cable becomes loose, please screw out the bolt and nut on the brake gear and pull the brake cable out with a clamp. Reposition the brake cable so that it is tense and screw the bolt and nut onto the brake gear all the while keeping the cable tight.
7. Over time the nuts and bolts may become loose, please check that all nuts and bolts are sufficiently tightened before each use of your scooter.

For your records, save your original sales receipt.

To register online go to:
http://www.yvolution.com/warranty

Customer service:
+44 800 802 1197
support@yvolution.com
+353 1 5242721
support@yvolution.com
+1 855-981-7177
support@yvolution.com

Documents / Resources

References

• Y Fliker, Balance Bikes & 3-Wheel Scooters | Yvolution

Download manual

Here you can download full pdf version of manual, it may contain additional safety instructions, warranty information, FCC rules, etc.

Download Y-Volution FLIKER CARVER C5, FLIKER C5 - Scooter Manual