Timer Operation - Aiwa CSD-NS1 Operating Instructions Manual

TAPE / REV MODE,
TUNER/ BAND,
CD
a
r, t
D

TIMER OPERATION

TIMER PLAYBACK/RECORDING
The unit can be turned on at a specified time every
day with the built-in timer.
Make sure the clock is set correctly.
1
Press TIMER twice for timer play or three
times for timer recording so that "5" or
"5 REC" flashes in the display.
2
Turn VOLUME/TIMER to specify the
timer-on time.
r or t is also available. Holding it down
changes the time in 20-minute units.
Timer-on time
3
Press ENTER or a.
4
Turn VOLUME/TIMER to specify the
timer-activated period.
The time changes between 5 and 180 minutes in
5-minute units. r or t is also available.
5
Press ENTER or a.
6
Prepare the source.
To listen to a CD, press CD and load the disc.
To listen to a tape, press TAPE/REV MODE and
load the tape.
To listen to a radio broadcast, press TUNER/
BAND and tune to the desired station.
To record from a radio broadcast, press
TUNER/BAND and tune to the desired station, and
load the tape to be recorded on.
7
Adjust the volume and tone, then turn off
the unit.
The unit turns on with the selected source at the
specified timer-on time, and turns off after the
specified timer-activated period.
12
ENGLISH
NOTE
• If you use the unit after setting the timer, repeat steps
6 and 7.
• Timer recording is available only when the source is
TUNER.
To check the timer setting
1 Press TIMER twice or three time.
The timer-on time is displayed.
2 Press ENTER.
The timer-activated period is displayed.
3 Press ENTER to restore the display.
To cancel the timer standby mode
Press TIMER repeatedly so that "5" or "5 REC"
disappears.
To reset the timer
Repeat all the steps above.
VOLUME/ TIMER
ENTER
TIMER
SLEEP