Volume Punchthrough Feature; Deleting All Volume Punchthrough Commands - RCA M50WH92S User Manual

Volume Punchthrough Feature

You may find this feature helpful if you've connected your devices to an audio system, and you
want to use the TV's remote control to operate the volume for a device that is connected to the
audio system. An example follows:
Let's say you've connected your DVD player to your audio system. You've also programmed your
TV remote control to operate your DVD player. Since the DVD player sends its volume through
the audio system, you would have to bounce back and forth between two remote controls: the
audio system's remote to adjust the volume and the TV's remote control to operate the DVD
player.
The Volume Punchthrough feature eliminates the need for you to use two remote controls and
saves a button press when you're using the TV remote to adjust the volume. In effect, you are
telling the TV remote to retrieve and send volume commands from the audio system whenever
the TV remote is in DVD mode.
Therefore, after you've successfully set up the Volume Punchthrough feature, whenever the TV
remote is in DVD mode (press the DVD button) and you want to adjust the volume, you only
have to press the VOL +/- or MUTE buttons. Follow the instructions below to set up Volume
Punchthrough.
1. On your remote control, simultaneously press and hold the ON•OFF and MUTE buttons
(approximately 3 seconds) until a device button remains lit. Then release the buttons.
2. Press and hold the MUTE button until the device button blinks off, then release the MUTE
button.
3. Press and release the device button that you programmed to operate the audio system
(receiver or amplifier).
4. Press and release the MUTE button.
5. Now, test it by turning on your audio system.
6. Turn on the device that is connected to the audio system (satellite receiver, for example).
7. Put the TV's remote in SAT•AUX mode by pressing the SAT•AUX button.
8. Press VOL+ or VOL-. The volume from the audio system should increase or decrease
accordingly.

Deleting aLL Volume Punchthrough Commands

To delete all programmed Volume Punchthrough settings and return the remote control back to
the factory default:
1. Simultaneously press and hold the ON•OFF and MUTE buttons (approximately 3 seconds)
until a device button remains lit. Then release the buttons.
2. Press and hold the MUTE button until the device button blinks off, then release the MUTE
button.
3. Press and release the MUTE button.
4. The remote returns to normal Volume/Mute control.
Chapter 2
Using the Remote Control
2