Senco SFW09 - Stapler Manual

Also See for SFW09:

Table of Contents

TOOL USE

	Read and understand "SAFETY INSTRUCTIONS" manual shipped with this tool before using tool.
	Keep tool pointed away from yourself and others and connect air to tool.
	To Load: Depress latch and slide rail open.
	Lay strip of staples into magazine. Use only genuine SENCO staples. Do not load with trigger depressed.
	Push rail forward until it latches.
	Never use a tool that leaks air or needs repair.
	To drive fasteners: Position tool against work surface and pull the trigger. These tools are not required to have a workpiece contact. USE CAUTION as these tools will drive a fastener when the trigger is pulled.
	Should a staple jam occur, disconnect air supply.
	Depress latch and slide rail open.
	Remove staples.
	Remove jammed fastener.
	Lay strip of staples onto rail. Use only genuine SENCO fasteners (see Parts Chart). Do not load with trigger depressed.
	Release staple door and slide it forward.

SENCO offers a full line of accessories for your SENCO tools, including:

For more information or a complete illustrated catalogue of SENCO accessories, ask your representative for #MK336.

	Read and understand "SAFETY INSTRUCTIONS" manual shipped with this tool before using tool.
	All screws should be kept tight. Loose screws result in unsafe operation and parts breakage.
	With tool disconnected, make daily inspection to assure free movement of trigger. Do not use tool if trigger sticks or binds.
	Squirt SENCO pneumatic oil (5 to 10 drops) into the air inlet twice daily (depending on frequency of tool use). Other oils may damage O-rings and other tool parts.
	Wipe tool clean daily and inspect for wear. Use non-flammable cleaning solutions only if necessary – DO NOT SOAK. Such solutions may damage O-rings and other tool parts.

Repairs other than those described here should be performed only by trained, qualified personnel. Contact SENCO for information at 1-800-543-4596.

Read and understand "SAFETY INSTRUCTIONS" manual shipped with this tool before using tool.

SYMPTOM	SOLUTION
Air leak near top of tool/Sluggish operation.	Verify air supply/tighten screws or install Repair Kit (YK0775).
Air leak near bottom of tool/Poor return.	Clean tool/tighten screws or install Repair Kit (YK0775).
Other problems.	Contact SENCO.

Minimum to maximum operating pressure	50–95 psi	3,5–6,6 bar
Air Consumption (60 cycles per minute)	.77 scfm	21,8 liter
Air Inlet	1 / 4 in. NPT	1 / 4 in. NPT
Maximum Speed (cycles per minute)	15 (Sencomatic)	15 (Sencomatic)
Weight	2.1 lbs.	0,95 kg
Staple Capacity	168	168
Tool size: Height	6 in.	152 mm
Tool size: Length	9 1 / 4 in.	235 mm
Tool size: Width: Main Body	1 5 / 8 in.	41 mm