Using The Power Saving Function - Pentax Optio RZ10 Operating Manual

Using the Power Saving Function

You can save battery power by setting the display to dim automatically
when no operation is performed for a fixed time. After the power saving
function has been activated, the display returns to the ordinary
brightness if any button is pressed.
1
Press the 3 button in Q mode.
The [W Setting] menu appears.
When you press the 3 button in A mode, press the four-way
controller (5) once.
2
Use the four-way controller (23) to select [Power
Saving].
3
Press the four-way controller (5).
A pull-down menu appears.
4
Use the four-way controller (23)
to select the time until the camera
enters the power saving mode.
Choose from [2min.], [1min.], [30sec.],
[15sec.], [5sec.] or [Off].
7
5
Press the 4 button.
The setting is saved.
• Power Saving does not function in the following situations:
- While taking pictures in j (Continuous Shooting) mode
- In the playback mode
- While recording a movie
- While the camera is connected to a computer
- While a menu is being displayed
• When no operation is performed after the camera is turned on, the
Power Saving function is activated only after 15 seconds elapse even
if [5sec.] is set.
200
Setting
Video Out
2min.
Eye-Fi 1min.
Brightness Level
30sec.
Power Saving 15sec.
5sec.
Auto Power Off
Off
Reset
Cancel Cancel Cancel
MENU
2/3
OK OK OK
OK