Basic Features - Panasonic KX-FP145 Operating Instructions Manual

8.2 Basic features

Code #00: Setting the Quick Setup
QUICK SETUP
PRESS SET
See page 15 for details.
Code #01: Setting the date and time
SET DATE & TIME
PRESS SET
See page 21 for details.
Code #02: Setting your logo
YOUR LOGO
PRESS SET
See page 22 for details.
Code #03: Setting your fax number
YOUR FAX NO.
PRESS SET
See page 23 for details.
Code #04: Printing a sending report
SENDING REPORT
MODE=ERROR [±]
To print a sending report for fax transmission
results (page 31).
"ERROR" (default): A sending report will be
printed only when fax transmission fails.
"ON": A sending report will be printed out after
every transmission.
"OFF": Sending reports will not be printed out.
Code #06: Changing the ring setting in
TAM/FAX mode (Telephone Answering
Machine/Fax mode)
TAM RING COUNT
RINGS=2 [±]
To change the number of rings before the unit
answers a call in TAM/FAX mode. You can select
"1", "2" (default), "3", "4", "TOLL SAVER" or
"RINGER OFF". See page 35 for details.
Note:
L Set feature #77 to "TAM/FAX" (page 54)
beforehand.
Code #06: Changing the ring setting in FAX
ONLY mode
FAX RING COUNT
RINGS=3 [±]
8. Programmable Features
To change the number of rings before the unit
answers a call in FAX ONLY mode.
You can select "1", "2", "3" (default) or "4".
Note:
L Set feature #77 to "FAX ONLY" (page 54)
beforehand.
Code #10: Changing the maximum incoming
message recording time
RECORDING TIME
MODE=VOX [±]
"VOX" (default): Unlimited.
"1 MIN": Up to 1 minute.
Code #11: Setting the remote operation ID
REMOTE TAM ID
ID=111
1. Press {MENU}.
2. Press {#}, then {1}{1}.
3. Enter any 3-digit number except a number
using 0 or 7.
L The default ID is "111".
4. Press {SET}.
5. Press {MENU}.
Code #13: Setting the dialing mode
DIALING MODE
MODE=TONE [±]
If you cannot dial, change this setting depending
on your telephone line service.
"TONE" (default): For tone dial service.
"PULSE": For rotary pulse dial service.
Code #17: Setting the ringer pattern
RINGER PATTERN
MODE=A [±]
You can select "A" (default), "B" or "C".
51