Panasonic Lumix DMC-FH22 Operating Instructions Manual page 135

[NOT ENOUGH SPACE ON BUILT-IN MEMORY]/[NOT ENOUGH MEMORY ON THE
CARD]
• There is no space left on the built-in memory or the card.
– When you copy pictures from the built-in memory to the card (batch copy), the pictures
are copied until the capacity of the card becomes full.
[SOME PICTURES CANNOT BE COPIED]/[COPY COULD NOT BE COMPLETED]
• The following pictures cannot be copied:
– When a picture with the same name as the picture to be copied exists in the copy
destination. (Only when copying from a card to the built-in memory.)
– Files not based on the DCF standard.
• Pictures recorded or edited by other equipment may not be copied.
[BUILT-IN MEMORY ERROR FORMAT BUILT-IN MEMORY?]
• This message will be displayed when you format the built-in memory on a PC.
" Format the built-in memory on the camera again.
memory will be deleted.
[MEMORY CARD ERROR FORMAT THIS CARD?]
• This card has a format which is not recognized by the camera.
" Format the card again with the camera after saving necessary data on a PC etc.
[PLEASE TURN CAMERA OFF AND THEN ON AGAIN]/[SYSTEM ERROR]
• This message appears when the camera is not operating properly.
" Turn the camera off and on. If the message persists, contact the dealer or your
nearest Service Center.
[MEMORY CARD PARAMETER ERROR]/[THIS MEMORY CARD CANNOT BE USED]
" Use a card compatible with this unit.
– SD Memory Card (8 MB to 2 GB)
– SDHC Memory Card (4 GB to 32 GB)
– SDXC Memory Card (48 GB to 64 GB)
[INSERT SD CARD AGAIN]/[TRY ANOTHER CARD]
• An error has occurred accessing the card.
" Insert the card again.
" Insert a different card.
[READ ERROR/WRITE ERROR PLEASE CHECK THE CARD]
• It has failed to read or write data.
" Remove the card after turning the power [OFF]. Insert the card again, turn the power
on, and try to read or write the data again.
• The card may be broken.
" Insert a different card.
Others
(P31)
(P18)
- 135 -
The data on the built-in
(P31)