Dear Customer Thank you for choosing one of our high-quality products. With this appliance you will experience the perfect combination of func- tional design and cutting edge technology. Convince yourself that our appliances are engineered to deliver the best performance and control - indeed we are setting the highest standards of excellence.
Safety The safety aspects of our refrigerators/freezers comply with accepted tech- nical standards and the German Appliance Safety Law. Nevertheless, we consider it our obligation to make you aware of the following safety infor- mation: Intended use • The refrigerator is intended for use in the home. It is suitable for the coo- ling, freezing and storing of frozen food, as well as for making ice.
appliances. It is therefore important that you ensure adequate supervision and never let children play with the appliance! Daily Operation • Containers with flammable gases or liquids can leak at low temperatures. There is a risk of an explosion! Do not store any containers with flamma- ble materials such as, for example, spray cans, fire extinguisher refill car- tridges etc in the refrigerator/freezer.
The carton parts are made from recycled paper and should be disposed of at a waste-paper recycling collection location. Disposal of old Appliances For environmental reasons, refrigeration appliances must be disposed of properly. This applies to your old appliance, and - at the end of its service life - for your new appliance as well.
Control panel A. Button for temperature regulation O O p p e e r r a a t t i i o o n n Remove, if present, the “Remove” label stuck on the inside of the freezer compartment. Insert the plug into the wall socket. S S w w i i t t c c h h i i n n g g o o f f f f To switch off the appliance remove the mains plug.
Temperatur regulation The temperature indicated by the LED is selected each time the button is pressed. The Selection is progressive,varying from +2 °C to +8 °C. Keep the button pressed until the LED corresponding to the required temperature lights up. Adjusting the temperature The temperature inside may be influenced by these factors.
Interior Accessories Storage shelves • You should always slide one of the full size glass storage shelf into the lowest set of guides, above the fruit and the vegetable containers, and keep it in this position. • The height of the storage shelves can be adjusted: •...
A A i i r r r r e e c c y y c c l l i i n n g g The refrigerator compartment is equipped with special D.A.C.(Dynamic Air Cooling) fan which can be turned on with the switch B with the green light on, means that the fan is working.
Freezing and storing frozen food You can use your freezer for freezing fresh food yourself. Important! • The temperature in the freezer compartment must be –18 °C or colder before freezing food. • Please observe the freezing capacity given on the rating plate. The free- zing capacity is the maximum quantity of fresh food that can be frozen within a period of 24 hours.
Move the shelf to the upper seat, keeping it horizontal. Place the fresh food to freeze on the shelf. After 24 hours,when the freezing process is completed, return to the required temperature by pressing the button “A”. Not open the door frequently or leave it open longer than absolutely neces- sary.
Installation of the charcoal filter On delivery the charcoal fil- ter is placed in a plastic bag to secure the length of life of the charcoal filter. The filter should be placed behind the flap before the appliance is turned on. •...
Defrosting Refrigerator Frost is automatically eliminated from the evaporator of the refrigerator compartment every time the motor compressor stops, during normal use. The defrost water drains out through a trough into a special container at the back of the appliance, over the motor compressor, where it evaporates. Freezer Your appliance is frost free, which means there is no need to manually defrost your appliance as this will be carried out automatically.
Clean the appliance and the interior accessories with a cloth and lukewarm water. Commercially available dish washing detergents may also be used. After cleaning wipe with fresh water and rub dry. Accumulation of dust at the condenser increases energy consumption. For this reason carefully clean the condenser at the back of the appliance once a year with a soft brush or a vacuum cleaner.
What to do if ... Correcting Malfunctions A malfunction may be caused by only a minor fault that you can rectify yourself using the following instructions. Do not perform any other work on the appliance if the following information does not provide assistance in your specific case.
Malfunction Possible Cause Remedy Appliance is not level. Readjust the feet. The appliance is touching the Move the appliance slightly. wall or other objects. Unusual noises. A component, e.g. a pipe, on If necessary, carefully bend the rear of the appliance is the component out of the touching another part of the way.
Please note that a valid purchase receipt or guarantee documentation is required for in-guarantee service calls. Customer Care Department For general enquiries concerning your AEG appliance or for futher information on AEG products, please contact our Customer Care Department by letter or telephone at the address below or visit our website at www.aeg.co.uk.
2. Should guarantee repairs be necessary the purchaser must inform the nearest AEG Servi- ce Force Centre (manufacturer’s service or authorised agent). AEG reserves the right to stipulate the place of the repair (i.e. the customer’s home, place of installation or AEG workshop).
Installation Electrical Connection Any electrical work required to install this appliance should be carried out by a qualified electrician or competent person. WARNING – THIS APPLIANCE MUST BE EARTHED The manufacturer declines any liability should these safety measures not be observed. Before switching on, make sure the electricity supply voltage is the same as that indicated on the appliance rating plate.
Positioning This appliance should only be installed at a location where the ambient temperature corresponds to the climate classification indicated on the rat- ing plate, which is located at the left on the inside of the appliance. The following table shows which ambient temperature is correct for each climate classification: SN +10°C to + 32°C +16°C to + 32°C...
Rear spacers Fit the rear spacers contained in the documentation bag to ensu- re even dissipation of heat gene- reted during operation. Proceed in the sequence illustrated by the figures. D594 Fitting the Door Handles Screw the top handle bracket to the handle rod (1).
Rehingeing the door The side at which the door opens can be changed from the right side (fac- tory adjustment) to the left side, if the installation site requires. Warning! When changing the side at which the door opens, the appliance may not be connected to the mains.
Page 24
into the hole on the left side of the freezer door. - Opening the doors, fix the middle hinge on the left side with two screws. Do not forget the plastic spacer that must be placed under the middle hinge (H). Pay attention that the border of the doors are parallel to the top border.
Regulations, Standards, Guidelines This appliance was designed for household use and was manufactured in accordance with the appropriate standards. The necessary measures in accordance with appliance safety legislation regulations (GSG), accident prevention regulations for refrigeration appliances (VBG 20) and the regu- lations of the German Society of Electrical Engineers (VDE) were observed in the manufacture of this appliance.
Page 28
Subject to change without notice 2223 457-61-00-20042007...
Need help?
Do you have a question about the SANTO 75328-1 DT and is the answer not in the manual?
Questions and answers