Manual Shutter Speed/Iris Adjustment - Panasonic HDC-SD700 Owner's Manual

Manual shutter speed/iris adjustment

Shutter Speed:
Adjust it when recording fast-moving subjects.
Iris:
Adjust it when the screen is too bright or too dark.
≥ Press the iA/MANUAL button to switch to Manual Mode. (l 75)
1
Touch [SHTR] or [IRIS].
2
Touch /
≥ Touch [SHTR]/[IRIS] to complete the adjustments.
Shutter speed:
SHTR
1/60 to 1/8000
≥ If [AUTO SLOW SHTR (2D)] is set to [ON], the shutter speed will be set between 1/30 and
1/8000.
≥ If [DIGITAL CINEMA] is set to [ON], the shutter speed will be set between 1/48 and 1/8000.
(When [AUTO SLOW SHTR (2D)] is set to [ON], the range is 1/24 to 1/8000.)
≥ The shutter speed closer to 1/8000 is faster.
≥ The shutter speed will be set between 1/2 and 1/2000 in Still Picture Recording Mode.
Iris/Gain value:
IRIS
CLOSE !# (F16 to F1.7) !# OPEN !# (0dB to 18dB)
≥ Value closer to CLOSE darkens the image.
≥ Value closer to 18dB brightens the image.
≥ When the iris value is adjusted to brighter than OPEN, it changes to the gain value.
≥ To return to auto setting, press the iA/MANUAL button again.
≥ When setting both the shutter speed and the iris/gain value, set the shutter speed and then
set the iris/gain value.
Manual shutter speed adjustment
≥ When the shutter speed is set lower than 1/15 in the Still Picture Recording Mode, using a
tripod is recommended. Also, white balance cannot be set. The shutter speed will be set to
1/30 when the unit is turned on again or when the Quick start is performed.
≥ You may see a band of light around an object that is shining very bright, or highly reflective.
≥ During normal playback, image movement may not look smooth.
≥ If you record an extremely bright object or record under indoor lighting, color and screen
brightness may change or a horizontal line may appear on the screen. In this case, record
in the Intelligent Auto Mode or set the shutter speed to 1/60 in areas where the power
supply frequency is 60 Hz, or 1/100 in areas of 50 Hz.
Manual iris/gain adjustment
≥ Luminance level and histogram are displayed during the iris adjustment. (l 70)
≥ If the gain value is increased, the noise on the screen increases.
≥ Depending on the zoom magnification, there are iris values that are not displayed.
to adjust settings.
77
VQT3K35