Panasonic HDC-SD700 Owner's Manual page 46

[CARD STATUS]
The used space and remaining recordable time of the SD card can be checked.
≥ When the mode switch is set to
mode is displayed.
≥ Touch [EXIT] to close the indication.
≥ The SD card requires some space to store information and manage system files, so the
actual usable space is slightly less than the indicated value. The usable space is generally
calculated as 1 GB=1,000,000,000 bytes. The capacities of this unit, PCs and software are
expressed as 1 GB=1,024k1,024k1,024=1,073,741,824 bytes. Therefore, the indicated
value of the capacity appears to be smaller.
[CALIBRATION]
Perform the touch screen calibration if a different object to the one touched is selected.
1 Touch [
CALIBRATION
≥ Touch [ENTER].
2 Touch the [_] that appears on the screen with the supplied stylus pen.
≥ Touch [_] in sequence (up left # down left # down right # up right # center).
3 Touch [ENTER].
[DEMO MODE]
This item is used to start the unit demonstration.
(Only when the mode is at the
If [DEMO MODE] is switched to [ON] and you touch [EXIT] when there is no SD card inserted
and while this unit is connected to the AC adaptor, the demonstration automatically starts.
If any operation takes place, the demonstration is canceled. However if no operations take
place for approx. 10 minutes, the demonstration automatically starts again. To stop the
demonstration, set [DEMO MODE] to [OFF] or insert an SD card.
[O.I.S. DEMO]
This item is used to start the Optical Image Stabilizer demo.
(Only when the mode is at the
Touch [O.I.S. DEMO], the demonstration automatically starts.
When you touch [EXIT], the demonstration will be canceled.
[LANGUAGE]
You can select the language on the screen display and the menu screen.
46
VQT3K35
, remaining recordable time for the selected recording
].
[OFF]/[ON]
or position)
position)