Remote Control - Optoma GT360 User Manual

Using the Remote Control
WXGA
Power
Contrast
L Button
R Button
Page +
Page -
Enter
Overscan
Source
HDMI
Re-SYNC
Four Directional
Select Keys
SVGA
Keystone +/-
Overscan
Volume +/-
Contrast
Brightness
Menu
Overscan

Remote Control

User Controls
Refer to the "Power On/Off the Projector"
section on pages 13-14.
Adjust the contrast of the image. (For SVGA
only)
No function.
No function.
No function.
No function.
Confirm your item selection.
Press "Source" to select an input signal.
Automatically synchronizes the projector to
the input source.
Use to select items or make
adjustments to your selection.
Adjust image distortion caused by tilting the
projector.
Adjust to increase / decrease the volume.
Adjust the brightness of the image.
Press "Menu" to launch the on-screen
display (OSD) menu. To exit OSD, press
"Menu" again.
Mask off a few pixels on each edge of the
image to be displayed. Use the function
to adjust if image source happens to have
noise near any edge of the display image.
19
English