Table 3 Error Code Descriptions - Nortel 10 Installation And Reference Manual

Book.book Page 21 Thursday, April 19, 2001 4:21 PM
Error codes are described in

Table 3 Error code descriptions

Error
Code Description
000 No error
001 Boot error
002 Memory check error
003 Flash integrity error
004 Stack overflow
the SNMP stack. For instance, many alarms are
registering and are not being addressed.
101 SNMP error
102 TFTP error
200 UPS communication error
201 No RPSU
202 Wrong RPSU type
300 Over temperature
301 Fan failure
999 General error
Table
—
There is too much information in
Installation and Reference for the BayStack 10 Power Supply Unit
Chapter 1 Introduction
3.
Action Required
None. System is functioning normally.
System failure—contact Nortel Networks
(see "How to get help" on page
System failure—contact Nortel Networks
(see "How to get help" on page
Reload the software using the TFTP
option. (Refer to Chapter 3, "Managing
the BayStack 10 PSU," on page 59
information about downloading the
software.)
Reboot the system (turn unit off/on).
Check the network (manager) status.
Check the network and TFTP server
status.
Check the UPS functionality—contact
Nortel Networks.
If the RPS slots are intentionally empty,
be sure that the cover plates are secured
to the rear panel.
If power supply modules are attached, be
sure that they are properly inserted into
the slots.
Contact Nortel Networks (see
help" on page 14).
Check the fans.
Replace the fans.
Reboot the system.
21
14).
14).
for
"How to get