Table 1 Leds On The Rps Controller Module; Table 2 Leds On The Ups Module - Nortel 10 Installation And Reference Manual

Book.book Page 19 Thursday, April 19, 2001 4:21 PM
Table 1
modules, and chassis.

Table 1 LEDs on the RPS controller module

Name
SYSTEM
RPSU
ENVIRONMENT: FF
Table 2
chassis.

Table 2 LEDs on the UPS module

Name
UPS:
BR
UPS:
BL
UPS:
BO
UPS:
BU
System
CHARGE
Down
LOAD
RPSU
Environment: FF
Environment: OT
describes the LEDs for the RPS controller module, power supply
Color
Green
Green
Yellow
describes the LEDs for the UPS module, power supply modules, and
Color Description
Yellow When yellow, replace the battery.
Yellow When yellow, indicates low battery.
Yellow When yellow, indicates battery operation is over voltage.
Yellow When yellow, indicates battery operation is under voltage.
Green System power of the device connected to power supply module 1, 2, 3, or
4 is operating normally.
Green Indicates level of remaining charge in battery.
Yellow Indicates the UPS is off-line.
Green Indicates load on battery from connected devices in increments of 25%.
Green Power supply modules 1, 2, 3, and/or 4 are operating normally.
Yellow Fan Fail: Fan operation has failed.
Yellow Over Temperature: Indicates that the UPS is over temperature.
Installation and Reference for the BayStack 10 Power Supply Unit
Chapter 1 Introduction
Description
System power of the device connected to power
supply module 1, 2, 3, or 4 is operating normally.
Power supply modules 1, 2, 3, and/or 4 are operating
normally.
Fan Fail: Fan operation has failed.
19