Page 3
WARNING WARNING Spiders and insects can nest inside the burner of To reduce the risk of fire, burn hazard or other injury, read the appliance and disrupt gas flow. Inspect the burner this safety manual carefully and completely before using at least once a year.
Page 4
• he parts which have been sealed by the manufacturer should not be adjusted by the user • When the appliance is using LPG & LPG cylinder should be used • The LPG cylinder size: max diameter-390mm, max height-455mm. • The minimum distances between the appliance and adjacent walls is 0.5m •...
Page 5
areas become extremely hot and could cause burns. • Do not use the oven to cook extremely fatty meats or other products which increase flare-up. • Keep the area around the oven free of combustibles, including liquids, garbage, and steam, such as gasoline or charcoal lighter fluid.Do not obstruct the flow of combustion and ventilation air.
Page 6
ASSEMBLY Before assembly, make sure all parts are present. If any part is missing or damaged, do not attempt to assemble the appliance. Contact customer service for replacement parts. 1. Unfold legs 2. Insert the baking board in the oven.
Page 8
5. Connect the gas hose to the TPOML3 Depending on your area, hoses may be pre-assembled 6. The minimum distance between the equipment and the cylinder is 0.6 m WARNING •Please always keep the gas bottle in upright position. •The size for 20 lbs LP gas cylinder is 390mm in diameter and 455mm tall •If the appliance is not in use, the gas must be turned off at the supply cylinder.
Page 9
PATIO GAS REGULATOR GAS REGULATOR This is a push-on gas fitting. Ensure This gas fitting is counterclockwise. that the black switch is in the Make sure that the tank is horizontal position. Depress the completely switched off and screw button located below the black switch the regulator as far as possible into and press the regulator on to the tank the gas tank valve.
DISCONNECTING THE LIQUID PROPANE GAS CYLINDER 1.Turn the oven burner valve OFF and make sure the oven is cool. 2.Turn the liquid propane cylinder valve OFF by turning clockwise until it stops. 3.Detach the regulator assembly from the cylinder valve by turning the quick coupling nut counterclockwise.
OPERATING INSTRUCTIONS USING THE OVEN 、Each burner is rated at 4.65KW. To begin: 1.Make sure the oven has been leak tested and properly placed. 2.Remove any remaining packing material. 3.Light the burner using the LIGHTING INSTRUCTIONS below LIGHTING INSTRUCTION TO LIGHT THE BURNER 1.Make sure the control knob is in OFF position, and then turn the liquid propane cylinder valve ON by slowly turning counterclockwise.
Wait for TPOML3 to cool completely before moving The outer shell of TPOML3 may fade over time and through use. This will not affect performance. STONE BAKING BOARD 1.DO NOT use the stone over an open flame 2.Avoid extreme temperature change to the stone.
TROUBLESHOOTING Problem Possible Cause Prevention/Solution 1. No gas flow 1. Check to see if propane tank is empty 2. Coupling nut and 2. Turn the coupling nut about one-half regulator not fully to three quarters additional turn until solid stop. Tighten by hand only – do connected Burner will not light 3.
Need help?
Do you have a question about the TPOML3 and is the answer not in the manual?
Questions and answers