KENT KFT142-210 Owner's Instruction Manual

Vesta gas fire table

Advertisement

Congratulations on your purchase of a Kent Gas Appliance.
Please read the following instructions carefully before use and
retain for future reference.
BEFORE FIRST USE
• Read and follow all the instructions below even if you feel you
are familiar with the appliance.
• Remove the packing and make sure that the appliance is
intact. If in doubt do not use the appliance and contact the
place of purchase.
• Do not leave packaging materials such as bags and staples
within reach of children.
• Dispose of packaging carefully and with consideration for the
environment.
For your convenience record the date you received the appliance
on the warranty page of these instructions, and attach your proof
of purchase. Retain this information in the event that a warranty
service is required.
DANGER
If you smell gas:
1. Shut off the gas to the
appliance.
2. Extinguish any open
flame.
3. If odour continues,
keep away from
the appliance and
immediately call your
gas supplier or fire
department.
Important: The installer or seller must leave these instructions with the consumer.
5638-08/24
VESTA GAS FIRE TABLE
Model No. KFT142-210
OWNERS INSTRUCTION MANUAL
CARBON MONOXIDE HAZARD
WARNING:
Do not store or use gasoline, or other
flammable vapors and liquids, in the vicinity
of this or any other appliance.
An LPG Cylinder not connected for use shall
not be stored in the vicinity of this or any
other appliance.
Improper installation, adjustment, alteration,
service or maintenance can cause injury
or property damage. Read the installation,
operating, and maintenance instructions
thoroughly before installing or servicing this
equipment.
Retain these instructions for future use.
STORAGE & MAINTENANCE
To obtain the best performance from your fire table, you must
perform the following storage and maintenance activities on a
regular basis:
• Allow at least 30 minutes for the fire table to cool down after
This appliance can
produce carbon
use, then disconnect and remove the cylinder.
monoxide which has
no odour.
• Store the gas cylinder in a dry, well ventilated and sheltered
Using it in an enclosed
area away from weather and dust, out of the reach of
space, eg. boat,
children, and not in a building, garage or any other enclosed
caravan, tent, car,
area.
campervan or house,
may cause death.
• Storage indoors is permissible only if the cylinder is
disconnected and removed. It is recommended that the
fire table be stored indoors during the winter if it will be
subjected to freezing temperatures.
• Keep the fire table area clear and free from combustible
materials, gasoline and other flammable vapors and liquids.
CARBON MONOXIDE HAZARD
• If the fire table is not in use, it must be covered to protect
from weather or other adverse elements.
This appliance can produce carbon
monoxide which has no odour.
• Never use a vacuum cleaner on the firebed stones.
Using it in an enclosed space, eg. boat,
• The fire table should be inspected at least annually by
caravan, tent, car, campervan or
a qualified service person. It is imperative that control
house, may cause death.
compartment, burners and circulating air passageways of the
fire table be kept clean.
CARBON MONOXIDE HAZARD
appliance in an enclosed space such as a
camper, tent, car or home.
WARNING:
For Outdoor Use Only
CARBON MON
This appliance can
produce carbon
monoxide which has no
odour.
Using it in an enclosed
space can kill you.
Never use this

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the KFT142-210 and is the answer not in the manual?

Questions and answers

Summary of Contents for KENT KFT142-210

  • Page 1 VESTA GAS FIRE TABLE Model No. KFT142-210 OWNERS INSTRUCTION MANUAL Congratulations on your purchase of a Kent Gas Appliance. STORAGE & MAINTENANCE Please read the following instructions carefully before use and To obtain the best performance from your fire table, you must retain for future reference.
  • Page 2 Installation, Operation and Maintenance Instructions Minimum Clearance from Combustibles: Important Safety Information: Sides 600 mm Above 1000 mm This appliance must only be used in a well ventilated area. DO NOT locate this appliance under any overhead enclosure. Avoid using near or under overhanging trees and shrubs.
  • Page 3 (2) DO NOT operate appliance without the grate 8. DO NOT use any pressure regulator or hose assembly other than those supplied with the appliance. Replacement in place; pressure regulator and hose assembly must be those Clothing or other flammable materials should not be hung specified.
  • Page 4: General Assembly

    PARTS LIST GENERAL ASSEMBLY Connecting & Disconnecting to Gas Source Part Name Table top assembly IMPORTANT: Before connecting and disconnecting appliance to gas source, make sure control knob is in Left front leg assembly ‘OFF’ position. Left rear leg assembly CAUTION: When the appliance is not in use, the gas Right front leg assembly must be turned off at the cylinder.
  • Page 5: Exploded Diagram

    EXPLODED DIAGRAM...
  • Page 6 ASSEMBLY INSTRUCTIONS Note: Remove any transit protection material. Your fire table must be installed on a flat, stable surface, away from any combustible materials or construction. Tools required: Assembly may require two people. • Philips head screwdriver (or cordless drill and bits). Lay cardboard down to protect gas fire table finish and •...
  • Page 7 Gas tank support assembly Adjustable feet ASSEMBLY INSTRUCTIONS Door assembly Burner assembly cover STEP 3 Attach the right side panel (6) Knob × × 12(8 and the back panel (7) to the legs with 8 M6x12 bolts (C). Door handle M6 butterfly bolt ×...
  • Page 8 Gas tank support assembly Adjustable feet ASSEMBLY INSTRUCTIONS Door assembly × × 12(4 Burner assembly cover STEP 5 Attach the front panel (9) with 4 Knob M6x12 bolts (C). Door handle M6 butterfly bolt × × × × 20 bolts C-20 12 bolts M6 x 12 bolt...
  • Page 9 Gas tank support assembly Adjustable feet ASSEMBLY INSTRUCTIONS Door assembly Burner assembly cover STEP 7 × × 20(4 Place the Gas Tank Support Knob Assembly (11) into the base as shown. Secure the Gas Tank Door handle × M6 butterfly bolt (1 Support Assembly with 4 M6x20 bolts (D).
  • Page 10 ASSEMBLY INSTRUCTIONS STEP 9 Insert an AA battery into the ignition button and attach knobs (15) to the control panel. Add the firebed stones into the firebed burner assembly. Ignition AA When not in use, place the burner battery not not included cover (14) on the fire table.
  • Page 11 ASSEMBLY INSTRUCTIONS GAS CONNECTION INSTRUCTIONS STEP 11 STEP 12 Turn on the gas cylinder ensuring that the control knob Ensure cylinder valve is in its full off position. Check Step 1 STEP 13 Step 5a STEP 14a STEP 13 STEP on the outdoor heater is turned OFF at this point.
  • Page 12: Storage And Maintenance

    TEST FIRING APPLIANCE STORAGE & MAINTENANCE Test fire appliance, following the lighting instructions found on To obtain the best performance from your fire table, you must the appliance. Leak test all gas connections with soapy water. perform the following storage and maintenance activities on a Soap bubbles indicate gas leakage.
  • Page 13: Troubleshooting

    TROUBLE SHOOTING Problem: Condition: Solution suggested: Igniter pin and burner are wet. Wipe dry with a cloth. Igniter pin cracked or broken. Contact retailer where purchased for replacement part. Appliance won’t Reconnect wire to the igniter box light located inside the table base behind Electrode wire is loose or disconnected.
  • Page 16 Aber Living reserves the rights to replace or repair the product the original consumer for use in a normal, domestic situation. within the warranty period. Warranty does not apply to any Kent Outdoor Gas Fire Tables: defect, deterioration (including corrosion if located within 1km 2 years from date of purchase.

Table of Contents