MSI 925XE Neo Platinum User Manual page 111

MS-7053 ATX Mainboard
After array mode is selected, there are two methods to create a disk array.
One method is "Auto Setup" and the other one is "Select Disk Drives". Auto
Setup allows BIOS to select the disk drives and create arrays automatically, but it
does not duplicate the mirroring drives even if the user selected Create and dupli-
cate for RAID 1. It is recommended all disk drives are new ones when wanting to
create an array. Select Disk Drives lets the user select the array drives by their
requirements. When using Select Disk Drives, the channel column will be activated.
Highlight the target drives that you want to use and press <Enter> to select them.
After all drives have been selected, press <Esc> to go back to the creation steps
menu.
If user selects a RAID 0 array in step 2, the block size of the array can also
be selected. Use the arrow key to highlight Block Size and press <Enter>, then
select a block size from the popup menu. The block size can be 4KB to 64KB.
6 - 6