MSI 915G Combo User Manual page 49

[Full Duplex], [Half Duplex]. Under [Full Duplex] mode, synchronous, bi-directional
transmission/reception is allowed. Under [Half Duplex] mode, only asynchronous, bi-
directional transmission/reception is allowed.
Parallel Port
This field specifies the base I/O port address of the onboard parallel port. Selecting
[Auto] allows AMIBIOS to automatically determine the correct base I/O port address.
Settings: [378], [278], [3BC] and [Disabled].
Parallel Port Mode
This item selects the operation mode for the onboard parallel port: [ECP], [Normal] or
[Bi-Dir].
Parallel Port IRQ
This item allows you to set parallel port IRQ. Setting options: [IRQ5], [IRQ7].
SATA Devices Configuration
Press <Enter> to enter the sub-menu and the following screen appears:
ATA/IDE Configuration, Configure SATA as
These 2 items allow you to select the ATA/IDE and SATA configuration. Select [Disabled]
in ATA/IDE Configuration if you want to disable both ATA/IDE configuration. Select
[Compatible] or [Enhanced] to use the IDE, S-ATA and P-ATA devices. Refer to the
following tables for details.
SATA Only
PATA Pri, SATA Sec
SATA Pri, PATA Sec
PATA Only
IDE
AHCI
RAID
For the setting options of Configure SATA as, select [IDE] if you want to have SATA
as IDE function. Select [AHCI] to allow the SATA to have Advanced Host Controller
Interface (AHCI) feature, which supports improved serial ATA disk performance with
native command queuing & native hot plug. Select [RAID] to use SATA as RAID
function. Setting options: [IDE], [AHCI], [RAID].
ATA/IDE Configuration
(Compatible)
[SATA 1/3/2/4]
[IDE1, SATA2/4]
[SATA1/3, IDE1]
[IDE1]
ATA/IDE Configuration
(Enhanced)
[IDE1, SATA 1/2/3/4]
[IDE1, SATA 1/2/3/4]
[IDE1, SATA 1/2/3/4],
[SATA support RAID 0 or 1]
BIOS Setup
3-13