MSI 915G Combo User Manual page 19

MS-7058 ATX Mainboard
11. Push down the CPU hardly to install
the CPU into the socket housing
frame.
13. Press down the load lever lightly
onto the load plate, and then se-
cure the lever with the hook under
retention tab.
15. Press the four hooks down to fas-
ten the cooler. Then rotate the lock-
ing switch (refer to the correct di-
rection marked on it) to lock the
hooks.
locking
switch
MSI Reminds You...
1. Check the information in PC Health Status of H/W Monitor in BIOS
(refer to p.3-20 for details) for the CPU temperature.
2. Whenever CPU is not installed, always protect your CPU socket pin
with the plastic cap covered (shown in Figure 1) to avoid damaging.
3. Please note that the mating/unmating durability of the CPU is 20 cycles.
Therefore we suggest you do not plug/unplug the CPU too often.
2-6
12. Visually inspect if the CPU is seated
well into the socket, then remove the
CPU Clip with 2 fingers. Then cover
the load plate onto the package.
14. Align the holes on the mainboard with
the cooler. Push down the cooler until
its four clips get wedged into the holes
of the mainboard.
16. Turn over the mainboard to confirm
that the clip-ends are correctly
inserted.