Section A
Appendix
• Turning the <Data> wheel will select the preset you wish to load at initial reset.
• Press the <PRESET> button again when the selection is complete. Normal resetting will
continue.
System Lock Out
• Press and hold <AFS> at power-up until one of the following messages appears (depending
on the current state of system lockout):
System Unlocked All user input will be accepted <AFS> to exit
System Locked! No user input will be accepted <AFS> to exit
Filter Unlocked. Filter clear will be accepted <AFS> to exit
•
Use the <DATA WHEEL> to select the desired state and then press the <AFS> button to
continue booting in the selected state.
•
The "System Unlocked" state allows normal operation.
•
The "System Locked" state is the complete lockout state. No user button input of any
kind will be acted upon.
•
The "Filter Unlocked" state is the same as the "System Locked" state except that the
<PRESET> and <AFS> buttons are accepted. Pressing <AFS> once will go to the AFS edit
page with the "Clear" parameter set to "LIVE" and the cursor on the third parameter
"Clear w/ <AFS>". Pressing and holding the <AFS> button will enable a filter clear. After
the clear, the DriveRack PX will return to the preset screen.
•
Locked operations will cause a "LOCKED" icon to appear in the upper right corner of the
screen for a few seconds.
DriveRack
or
or
PX
®
®