MSI Crystal 945 User Manual page 51

M S-6422
SuperIO Device
Press <Enter> to enter the sub-menu and the following screen appears:
Onboard FDC Controller
Select [Enabled] if your system has a floppy disk controller (FDD) installed on
the system board and you wish to use it. If you install add-on FDC or the system
has no floppy drive, select [Disabled] in this field.
Onboard Serial Port 1
Select an address and corresponding interrupt for the serial port.
Onboard Parallel Port
There is a built-in parallel port on the on-board Super I/O chipset that provides
Standard, ECP, and EPP features.
Parallel Port M ode
[SPP]
[EPP]
[ECP]
[ECP + EPP]
To operate the onboard parallel port as Standard Parallel Port only, choose
[SPP]. To operate the onboard parallel port in the EPP mode simultaneously,
choose [EPP]. By choosing [ECP], the onboard parallel port will operate in ECP
mode only. Choosing [ECP + EPP] will allow the onboard parallel port to support
both the ECP and EPP modes simultaneously.
ECP Mode Use DMA
The ECP mode has to use the DMA channel, so choose the onboard parallel port
with the ECP feature. After selecting it, the following message will appear:
"ECP Mode Use DMA." At this time, the user can choose between DMA channel
[3] or [1].
3-14
Standard Parallel Port
Enhanced Parallel Port
Extended Capability Port
Extended Capability Port + Enhanced Parallel Port