Chapter 4: Installing The Presentation Player's Setup Utility; Overview - Linksys WPG12 User Manual

3. To have a wired connection, connect one end of the Category 5 Ethernet
network cable to your PC's Ethernet adapter. Connect the other end to the
Ethernet port on the back of the Presentation Player.
4. Place the Player near the monitor or projector facing the presenters so the
infra red in the remote control will have access to the Player.
5 For a wireless connection, fix the direction of the antennas. Try to place it
in a position which can best cover your wireless network. Normally, the
higher you place the antenna, the better the wireless performance will be.
The antenna's position enhances the receiving sensitivity. Both antennas
should be perpendicular to the ground and parallel to each other.
8
Instant Wireless
Figure 3-3
Series Presentation Player
TM
Chapter 4: Installing The
Presentation Player's Setup Utility

Overview

The Presentation Player can play from any PC in your wireless network. You will
need to install this utility in each PC that will be used with the Presentation Player –
once installed, it will not need to be done again.
1. Insert the Setup CD-ROM into your CD-ROM drive. The CD's InstallShield
Wizard should start automatically. If it does not start automatically, click the
Start button, select Run, and type d:\setup.exe (where "d" is the letter of your
CD-ROM drive) in the Open field to start the autorun program.
2. The Welcome page for the Setup Utility will appear (as shown in Figure 4-1.).
Click the Install tab to start the installation procedure and place the Setup Utility
on your current PC. Click Uninstall to begin a simple procedure for removing
the Setup Utility. Click the User Guide tab to use this User Guide. If you need
to contact Linksys for technical support, click the Contact Us tab for that infor-
mation. Click the Exit tab to close the Setup Utility.
Figure 4-1
Note: If you click Cancel at any time, you will have to re-start the
installation procedure.
9