Lenovo ThinkPad X60 1706 Hardware Maintenance Manual page 52

Symptom-to-FRU index
46
MT1702/1703/1704/1705/1706/1707/1708/1709/2507/2508/2509/2510/2533/2534
Symptom or error
1810
Hard disk partition layout error.
1820
More than one external fingerprint reader is
attached. Power off and remove all but the
reader that you set up within your main
operating system.
2000
Hard Drive Active Protection sensor
diagnostics failed.
Press <Esc> to continue.
Press <F1> to enter SETUP
2010
Warning: Your internal hard disk drive
(HDD) may not function correctly on this
system. Ensure that your HDD is supported
on this system and that the latest HDD
firmware is installed.
2100
Initialization error on HDD0 (Main hard
disk drive)
2102
Initialization error on HDD1 (Ultrabay hard
disk drive)
FRU or action, in sequence
1. If the Access Predesktop Area has been
previously disabled, then go to the
BIOS Setup Utility by pressing F1 to
open the BIOS Setup Utility. Select
Security --> Predesktop Area --> Access
Predesktop Area. Set this item to
Disabled. Save and exit.
2. If the Access Predesktop Area has not
been previously disabled, press Enter to
load Access Predesktop Area. Then run
RECOVER TO FACTORY CONTENTS
in Access Predesktop Area.
3. If item 2 failed, press F3 in the Welcome
screen in RECOVER TO FACTORY
CONTENTS. Run FDISK, and then
delete all partitions. Run RECOVER TO
FACTORY CONTENTS in Access
Predesktop Area again.
4. If item 3 failed, select CD-ROM boot in
Startup in Access Predesktop Area. Boot
from the Recovery CD and perform full
recovery from it.
5. If item 4 failed, replace the hard disk
drive.
Remove all but the reader that you set up
for the authentication.
1. Undock docking station or port
replicator if it is attached to the
ThinkPad computer, and place the
computer on a horizontal surface. Do not
apply any physical shock to the
computer.
2. Run Diagnostics --> ThinkPad Devices
--> HDD Active Protection Test.
Inform the following information to the
customer:
If in the primary bay the customer is using a
non-IBM or non-Lenovo hard disk drive
(HDD), or an old generation IBM HDD
which is not supported by this system, with
the risk in mind, the customer can still use it
by pressing ESC. If in the primary drive bay
the customer is using a supported
IBM/Lenovo HDD with an old firmware,
the customer needs to update its firmware to
the latest. The latest version is available at
http://www.lenovo.com/support
1. Reseat the hard disk drive.
2. Main hard disk drive.
3. System board.
1. Reseat the hard disk drive.
2. Ultrabay hard disk drive.
3. System board.