Operating Instructions; Quick Start - LG LDF9932 User Manual

O P E R AT I N G I N S T RU C T I O N S

QUICK START

1 LOAD THE DISHES
Scrape the dishes free of excess food, bones,
and any other hard, non-soluble residue. Pull
each rack out and load the dishes as
described on pages 13 and 14.
MEASURE THE DETERGENT
2
Using the guidelines on page 16, fill the
detergent cup with the recommended amount
of detergent and close the lid. If a prewash is
desired, the recess on top of the lid should
also be filled with detergent.
TURN ON THE DISHWASHER
3
To start the cycle, open the door and press
the Power button.
4 CHECK THE RINSE AID
The Rinse Aid indicator light will illuminate if
the level of rinse aid in the dishwasher is low.
Add rinse aid if the level is low to maintain the
effectiveness of the dry cycle.
wCAUTION
Empty the lower rack first and then the upper
rack. This will avoid water dripping from the
upper rack onto dishes in the lower rack.
wWARNING
In general, it is not advisable to open the door
while the dishwasher is in operation. If the door
is opened, a safety device stops the dishwasher.
Care should be taken when opening the door
immediately following the cycle, as steam may
escape.
NOTE :
If small hard items such as bones, nut shells or plastic or glass pieces get into the pump, they can
cause a grinding noise as the soft food disposer in the dishwasher attempts to grind up these hard
objects. Some objects that might get into the pump could eventually be ground up and drained away.
However, if a grinding noise is heard and it does not go away, call for service to have the objects
removed from the pump. Some objects such as pieces of glass could cause damage to the pump if not
removed promptly.
10
SELECT THE CYCLE AND OPTIONS
5
Select the cycle and options that best fit the
load by referring to the chart on page 11. The
display will show the estimated time for the
cycle and options selected.
CLOSE THE DOOR
6
The dishwasher will start automatically, after a
slight delay, when the door is closed and
latched. During the cycle, the display will
indicate the estimated time remaining for the
cycle and options selected. If the door is
opened during the cycle, the dishwasher will
stop. When the door is closed, the cycle will
resume from the point where it was stopped.
END OF CYCLE
7
When the cycle is completed, a chime will
sound and the display will show "END." After a
short time, the display and controls will shut
off for safety and energy conservation.
AUTO-OFF
The dishwasher will automatically turn off if a cycle
is not selected or if the door is not closed within 10
minutes.