Kyocera Mita FS-1900N Operation Manual page 41

Entering the Width and Length
Then, use the following procedure to set the paper size.
Enter the paper size for X Dimension and Y Dimension as
shown in the figure.
148 to 216 mm
(5.83 to 8.5 inches)
1
When the unit of measurement is set, press the
>>X Dimension appears as shown below (the paper width setting).
>>X Dimension
2
Press the ENTER key. A blinking cursor (
>>X Dimension
3
Press the or
where the cursor is blinking and display the desired width. The
width can be set between 148 and 216 mm (5.83 to 8.5 inches). You
can use the > and < keys to move the cursor right and left.
4
Display the paper width and press the ENTER key.
5
When the width is set, press the
(the paper length setting). Set the desired length in the same way as
the width. The length can be set between 210 and 356 mm (8.27 to
14.02 inches).
6
Display the paper length, press the ENTER key.
X Dimension
216 mm
216 mm
key to increase or decrease the value of the figure
1-27
Paper Handling
key.
) appears.
key. >>Y Dimension appears