Kyocera Mita FS-1900N Operation Manual page 30

Printing Test Pages
1 — Software Version
This information shows the firmware version and date of issue of the
printer.
2 — Hardware Information
This information shows various printer settings, such as the size and type
of the paper in the paper cassettes.
3 — Memory
This shows the amount of total memory installed in the printer, the
amount of currently available memory, and the current status of the RAM
disk. See Operating the Storage Device on page 1-81.
4 — Page Information
This shows the print resolution, number of copies, and the total page count.
5 — Installation Options
This shows the option(s) installed in the printer.
6 — Network Status
This shows the IP address, Subnet Mask address, and Default Gateway
address for the network interface card installed in the printer.
7 — Emulation
This shows all available emulations of the printer. The printer is shipped
from the factory with PCL 6 emulation selected as the default.
8 — Error Log
This shows the last three instances of the following four types of errors,
listing them in the order of their occurrence: KPDL Error Press GO;
Memory overflow Press GO; Print overrun Press GO; File not
found Press GO. The most recent error is displayed on the top line of the
Error Log. For error remedies, see section Error Messages on page 4-10.
Error information is cleared when the printer's power is turned off.
9 — Toner Gauge
This shows the approximate level of remaining toner. When the value is
100, the toner container is full.
1-16