Install And Remove Sfp Modules; Remove The Sfp Modules - Cisco C1113-8PMWE Hardware Installation Manual

Install and Upgrade Internal Modules and FRUs

Install and Remove SFP Modules

This section describes how to install optional small-form-factor pluggable (SFP) modules in the router to
provide optical Gigabit Ethernet connectivity.
The SFP module is installed into a slot on the rear panel of C111x series. Only SFP modules certified by Cisco
are supported on these routers. For more information, refer to
Note The SFP module-GLC-GE-100FX V01 is not supported on the Cisco 111x Series.
Warning
Class 1 laser product. Statement 1008.

Remove the SFP Modules

To remove an SFP module from the router:
Warning Invisible laser radiation may be emitted from disconnected fibers or connectors. Do not stare into beams or
view directly with optical instruments. Statement 1051
Step 1
Disconnect the power supply before you remove any module.
Step 2 Disconnect all cables from the SFP.
Step 3
Disconnect the SFP latch.
Note SFP modules use various latch designs to secure the module in the SFP port. For information on the SFP
technology type and model, see the label on the side of the SFP module.
Use a pen, screwdriver, or other small straight tool to gently release a bale-clasp handle if you cannot reach it
Tip
with your fingers.
Step 4 Grasp the SFP on both sides and remove it from the router.
Hardware Installation Guide for the Cisco 1000 Series Integrated Services Router
Install and Remove SFP Modules
SFPs Supported on Cisco 1100 ISRs.
49