Wire The Focus H1; Power Harness; Monitor - Coban FOCUS H1 Installation Manual

COBAN Technologies Inc.
3. Attach the camera mount bracket to the wall mount plate with the (4) provided 8-32
screws, make necessary adjustments to properly aim the camera.
4. Route the cable behind the camera so it is not visible.
NOTE:
Tighten the screws securely and verify that the camera does not move when finished.
Wall Mount Plate Camera Mount Bracket

2.7 Wire the FOCUS H1

2.7.1 Power Harness

To wire the FOCUS H1 using the Power Harness, follow these steps:
1. Using the Power Harness, run the RED and BLACK wires from the CPU to the vehicle's
battery.
2. Attach the BLACK wire to ground.
3. Take the inline fuse holder and remove the fuse.
4. Securely attach the fuse holder in-line to the RED wire and then attach to the positive
side on the battery.
5. Run the ORANGE wire to the dash and connect it to an ignition source.
NOTE: Some early versions of the power harness included a YELLOW wire for Ignition.
6. Connect the Power Harness to the power pigtail on the CPU.
7. Reattach the fuse back into the fuse holder.

2.7.2 Monitor

To wire the monitor, follow these steps:
1. Run the monitor extension cable marked #0 from the monitor location to the CPU.
NOTE: The cable # is on the bottom side of the connector.
2. Connect the monitor pigtail to the monitor extension cable.
COBAN FOCUS H1 In-car Video System Installation Guide v1.0.2
Step -1 Step -2 Step -3 Step -4
Page | 8