Page 1
SWP-2800 Battery Sweeper Operator and Parts Manual Model No.: 607444 CASTEX 12875 RANSOM STREET HOLLAND MI 49424 U.S.A. 608795 FAX: 1–800–678–4240 Rev. 03 (01-02) CUSTOMER SERVICE: 1–800-964–9644 Home Find... Go To..
Report machine damage or faulty operation immediately. – Do not soak up liquids. – Do not leave machine unattended. 4. Before leaving or servicing machine: – Stop on level surface. – Turn off machine. – Remove key. SWP-2800 (01-02) Home Find... Go To..
8. Front waste bin: collects debris. 9. Rear waste bin: collects dust. 10. Side brush: this brush enables machine to clean close to walls. 11. Upper Cover: Covers internal components. 12. Wall Bumpers: Protects wall from damage. SWP-2800 (01-02) Home Find... Go To..
These will help you to d. Tighten with the 5mm Hex Driver (wrench). get the best results from your machine and reduce the chance of possible machine damage. 4. Preparing the battery. SWP-2800 (01-02) Home Find... Go To..
Grasp the handle and pull the bin out of the machine. – Brushes are running freely. c. Empty the bin. – Battery is completely charged before starting. d. Fit the bin back into the machine. e. Turn and lower the two locks. SWP-2800 (01–02) Home Find... Go To..
They must be disposed of in ATTENTION: Waste must be disposed of strictly in accordance with the relevant laws. accordance to the law. SWP-2800 (01–02) Home Find... Go To..
1. Remove the front waste bin and slacken the four fixing screws to remove the brush. 2. When mounting a new brush, pay attention to the direction in which the brush will spin; it must direct dirt toward the center of the machine. SWP-2800 (01–02) Home Find... Go To..
4. Grasp flap 4 and pull it outwards. 5. Remount the flaps in the same direction in which they are removed. 6. Insert the two references in their holes. 7. Tighten the two fixing pins. SWP-2800 (01–02) Home Find... Go To..
See example below: 3. Loosen the cable clamp. 4. Loosen the security dowel on the fixing pin. 5. Remove the handle from the support and open it 6. Pull the cable out of the two sheaths. SWP-2800 (01–02) Home Find... Go To..
The motor has burnt out. Replace motor. not work. The wire is disconnected. Repair connection. The machine does not The battery terminals are disconnected. Reconnect terminals. turn on. The battery is discharged. Recharge battery. SWP-2800 (01-02) Home Find... Go To..
BATTERY RUN TIME 2.5 h FILTERING SURFACE 690 mm ( 27 in) PRODUCTIVITY 26,900 sq. ft../2500m per hour INSTALLED POWER 360W/28A BATTERY TYPE 12V, 105A NOISE LEVEL AT OPERATOR’S EAR 77.2 dB(A) VIBRATIONS 2,5 m/Sec SWP-2800 (01-02) Home Find... Go To..
M 3: SUCTION FAN MOTOR M 3: SUCTION FAN MOTOR F.x: FUSES F.x: FUSES L 1: BATTERY LEDS L 1: BATTERY LEDS L 2: FAN INDICATOR LED L 2: FAN INDICATOR LED L 3: POWER INDICATOR LED L 3: POWER INDICATOR LED SWP-2800 (01-02)
Need help?
Do you have a question about the SWP-2800 and is the answer not in the manual?
Questions and answers