Datalogic Modem Quick Reference page 19

DATALOGIC
SET RADIO ADDRESSES
Follow the procedure below to set the STAR Modem™ radio address and prepare it
to receive and transmit data to all devices included in the range from the First to the
Last STAR-System™ destination device.
1.
Enter Configuration
2.
Set STAR Modem™ Radio Address
xxxx = four digits for the STAR Modem™ address (from
0000 to 1999). This address must be unique.
3.
First STAR-System™ Destination Device Address
xxxx = four digits for the Destination Device address (from
0000 to 1999).
4.
Last STAR-System™ Destination Device Address
xxxx = four digits for the Destination Device address (from
0000 to 1999).
If transmitting to one Destination device only, this selection
is not required.
5.
Set RF Baud Rate (not for USA model)
x = 0 defines 9600 baud
1 defines 19200 baud
6.
Exit and Save Configuration
When defining a range of destination device addresses, STAR Modem™ activates
roaming towards all the devices included within this range.
No interface selection is required, since all STAR-System™ transactions occur via
serial interface.
UK/US
$+
MA1RCxxxx
MSxxxx
MTxxxx
MFx
$-CR
11